一种注塑机锁模系统的理论计算与模拟分析
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

TQ320.5

基金项目:

国家自然科学基金资助项目(10972076,10672197);湖南省杰出青年基金(07JJ1001);湖南省自然科学基金资助项目(09JJ6083);湖南省教育厅项目(09C317,09C318);湖南省研究生科研创新基金(XC2010B400)


A Clamping System for Injection Machine
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    在肘杆式、液压直压式、伺服电机直压式三种注塑机锁模机构优缺点基础上提出了利用金属材料热胀冷缩性质实现模具锁紧的锁模系统。分别从材料选择、加热及冷却过程等方面对该系统进行了理论计算,最后利用ANSYS10.0有限元分析软件对该系统在特定工况下的工作性能进行了全真模拟分析。结果表明,该锁模系统是一种精密、稳定、安全、无污染、快速高效的锁模系统。

    Abstract:

    A clamping system based on thermal expansion of metals was developed based on the characteristics and disadvantages of elbow bar-type,hydraulic direct compressed and servo motor direct compressed clamping systems for injection machine.The material performance,heating and cooling process and their efficiency of this clamping system were calculated.And then the working performance of this clamping system on specific operating condition was simulated with Finite Element Analysis software ANSYS 10.0.It proved this new mechanism to be an accurate,stable,safe,pollution-free,rapid and efficient clamping mechanism.

    参考文献
    相似文献
    引证文献
引用本文

曾广胜,瞿金平,江太君,刘跃军.一种注塑机锁模系统的理论计算与模拟分析[J].高分子材料科学与工程,2012,28(2):169-173. Guangsheng Zeng, Jinping Qu, Taijun Jiang, Yuejun Liu. A Clamping System for Injection Machine[J]. Polymer Materials Science & Engineering,2012,28(2):169-173.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2013-04-16
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司