主链刚性对磺化聚芳醚砜电解质膜性能的影响
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

TM911.48

基金项目:

江苏省自然科学基金资助项目(BK2010482);南京理工大学自主科研重大专项(2010ZDJH03);南京理工大学自主科研专项资助项目(2010GJPY088);南京理工大学“紫金之星”计划(2010)


Influence of Backbone Rigidness on the Performance of Sulfonated Polyether Sulfone Electrolyte Membranes
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    以六氟双酚A(HFBPA)、9,9′-双(4-羟苯基)芴(BHPF)、4,4′-二氟二苯砜及3,3′-二磺酸钠-4,4′-二氟二苯砜为原料,经高温缩聚成功合成了一系列磺化聚芳醚砜(SPAES),并通过改变BHPF及HFBPA的比例来调节聚合物主链的刚性。结果表明,随刚性组分BHPF含量的增加,SPAES膜吸水率及质子导电率降低、但在水中的稳定性增加。在BHPF与HFBPA的比例为1∶1及磺化度为50%(SPAES50-50)条件下,膜在60℃水中平面和厚度方向的尺寸变化分别为0.12和0.13,电导率达到0.137 S/cm,而经130℃高温水处理200 h后的失重率仅为7%,表明其有望在高温燃料电池中得到应用。

    Abstract:

    A series of novel sulfonated poly(arylene ether sulfone)(SPAES) copolymers were successfully synthesized from 6F-bisphenol A(HFBPA),9,9′-bis(4-hydroxyphenyl) fluorine(BHPF),4,4′-difluorodiphenyl sulfone(DFDPS) and 3,3′-disulfonate-4,4′-difluorodiphenyl sulfone(SDFDPS) via high temperature copolymerization.The rigidness in the polymer backbone was controlled by the ratio of BHPF to HFBPA.As the increase in the ratio of BHPF,the SPAES membranes display increased stability towards water but lower water uptake and proton conductivity.The membrane of SPAES50-50(BHPF/HFBPA 50/50 in molar ratio and 50% sulfonation degree) exhibits dimensional change of 0.12 and 0.13 in the plane and thickness direction,respectively,and proton conductivity of 0.137 S/cm in water and at 60 ℃,as well as mass loss of 7% after aging treatment for 200 h in water at 130 ℃,suggesting their potential application in the high temperature fuel cell field.

    参考文献
    相似文献
    引证文献
引用本文

刘健美,胡朝霞,陈珊珊,荣艺,王明东,魏松波,陈守文.主链刚性对磺化聚芳醚砜电解质膜性能的影响[J].高分子材料科学与工程,2012,28(5):85-88. Jianmei Liu, Zhaoxia Hu, Shanshan Chen, Yi Rong, Mingdong Wang, Songbo Wei, Shouwen Chen. Influence of Backbone Rigidness on the Performance of Sulfonated Polyether Sulfone Electrolyte Membranes[J]. Polymer Materials Science & Engineering,2012,28(5):85-88.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2013-04-16
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司