可膨胀石墨/环氧树脂体系的固化动力学
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

TQ323.5

基金项目:


Curing Kinetics of Expanded Graphite/Epoxy Resin System
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用非等温差示扫描量热(DSC)法分别对环氧树脂(EP)及可膨胀石墨/环氧树脂(EG/EP)体系的固化过程进行了研究。利用Kissinger和Crane法计算得到两种体系固化反应的表观活化能Ea、指前因子A、固化反应级数n等动力学参数,建立了固化反应动力学方程,并用T-β外推法确定了固化工艺温度。结果表明,EG的加入,降低了EP体系固化反应的完全程度,对固化反应时间的影响不大,体系的Ea由63.15 kJ/mol升高到65.89 kJ/mol,A由2.02×107提升到4.5×107,两种体系的反应级数基本一致,同时,EG的加入对体系固化工艺温度影响不大。

    Abstract:

    The curing reactions of epoxy resin(EP) and epoxy resin filled with expanded graphite(EG) were studied by means of non-isothermal differential scanning calorimetry(DSC).The curing kinetics parameters of systems were calculated by Kissinger and Crane method.The apparent activation energy,reaction orders and the pre-exponential factor and the kinetic equation of the curing reaction of systems were established.Curing temperature was calculated by extrapolating Tβ.At the same time,the Tg of systems was determined.The results show that the full extent of the curing reaction of EP system is reduced by adding EG,but which has little effect on the curing reaction time system,Ea increases from 63.15 kJ/mol to 65.89 kJ / mol,A upgrades from 2.02×107 to 4.5×107,the two systems almost have the same reaction order,addition of EG has little effect on the curing process temperature of EP system.

    参考文献
    相似文献
    引证文献
引用本文

郑岩.可膨胀石墨/环氧树脂体系的固化动力学[J].高分子材料科学与工程,2012,28(6):98-101. Yan Zheng. Curing Kinetics of Expanded Graphite/Epoxy Resin System[J]. Polymer Materials Science & Engineering,2012,28(6):98-101.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2013-04-16
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司