琼脂糖醋酸酯纳米粒子的制备及药物缓释性
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

TB383.1

基金项目:

国家自然科学基金资助项目(30872404)


Preparation and in Vitro Controlled Release of Drug-Loaded Agarose Acetate Nanoparticles
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    通过纳米沉淀法制备了一种粒径均一的琼脂糖醋酸酯纳米粒子,并对影响粒径的相关因素进行了研究。结果表明,纳米粒子分别随着二甲基亚砜(DMSO)与水的比率、姜黄素含量及琼脂糖醋酸酯(AA)的浓度的增加而增大,随转速的增加而下降,异丙醇和聚乙烯醇(PVA)浓度也有一定的影响。同时研究了载体对姜黄素的包载情况及缓释行为。结果显示,无异丙醇组中姜黄素载药率和包封率均比异丙醇组中的高。但两组都表明,随着姜黄素的含量增加,载药粒子的载药率不断增加,包封率不断降低。载药粒子大大延长了姜黄素的缓释时间。获得的琼脂糖醋酸酯纳米粒子可望用于姜黄素的控释。

    Abstract:

    In this paper,the preparation of uniform agarose acetate nanoparticles(AA-NPs) by nanoprecipitation was investigated with the following conditions:(1) emulsifier PVA concentration,(2) co-emulsifier isopropanol,(3) AA concentration,(4) the ratio of dimethyl sulfoxide(DMSO) to water,(5) the stirring rate,and(6) drug content.The results show that the size of AA-NPs has a close relationship with conditions above.In addition,the drug loading capacity and in vitro drug release of the AA-C-NPs were investigated.The results show that the loading rate and encapsulation efficiency of AA-C-NPs without isopropanol are higher than that with isopropanol.But both of them show a tendency that the loading rate obviously increases but encapsulation efficiency decreases with increasing of initial curcumin concentration.The result of in vitro release shows a burst effect at the beginning stage,a slow and continuous release followed.

    参考文献
    相似文献
    引证文献
引用本文

张令辉,尤玲玲,张灵敏,汤顺清,蔡继业.琼脂糖醋酸酯纳米粒子的制备及药物缓释性[J].高分子材料科学与工程,2012,28(7):116-119,123. Linghui Zhang, Lingling You, Lingmin Zhang, Shunqing Tang, Jiye Cai. Preparation and in Vitro Controlled Release of Drug-Loaded Agarose Acetate Nanoparticles[J]. Polymer Materials Science & Engineering,2012,28(7):116-119,123.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2013-04-16
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司