聚丙烯/纳米二氧化钛复合材料的超临界流体微孔发泡
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

TB383.1

基金项目:

国家安全重大基础科研项目(51340030202)


Microcelluar Foaming of Polypropylene/Nano-TiO2 Blends Using Supercritical CO2
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    以聚丙烯(PP)/nano-TiO2复合材料为研究对象,采用快速降压超临界微孔发泡技术,制备了泡孔密度、泡孔直径分别为2.8×107cell/cm3~3.15×109cell/cm3,46.36μm~6.08μm的PP/nano-TiO2微孔复合材料。研究了复合材料中nano-TiO2的质量分数、饱和压力及发泡温度对PP/nano-TiO2复合材料发泡行为的影响,通过扫描电镜(SEM)对微孔形貌进行表征。结果表明,加入nano-TiO2可以改善PP的发泡性能,并得到泡孔分布均匀的闭孔发泡材料;随复合材料中nano-TiO2质量分数由1%提高到5%,泡孔密度增加,泡孔直径减小。对于nano-TiO2质量分数为3%的PP/nano-TiO2复合材料,随着饱和压力的增加,泡孔直径和泡孔密度都增加;随着发泡温度的升高,泡孔密度减小,泡孔直径变大。

    Abstract:

    This research presents the foaming behaviors of polypropylene/nano-TiO2 nanocomposites which blown with supercritical CO2 during rapid pressure reduction process.Microcellular nanocomposities with 2.8×107 cm-3 to 3.15×109 cm-3 cell density and 46.36 μm to 6.08 μm cell diameter were prepared.Through studying the effects of nano-TiO2 quality score,saturation pressure,foaming temperature on the foaming behavior of PP/nano-TiO2 composite materials,the cell structures are characterized by Scanning electronic microscopy (SEM).The experimental results indicated that the addition of nano-TiO2 can significantly improving the foaming behaviors of PP,foaming materials with can be cell distribution more evenly of closed pore obtained.With the nano-TiO2 content increasing,the cell diameter reduced and the cell density increased,in addition,the cell distribution was more uniform.For the PP/nano-TiO2 composite materials with 3% nano-TiO2,when the saturation pressure increased,both the cell diameter and cell density increased.The cell diameter increased and the cell density decreased with the elevated temperature.

    参考文献
    相似文献
    引证文献
引用本文

李彩凤,应三九,肖正刚.聚丙烯/纳米二氧化钛复合材料的超临界流体微孔发泡[J].高分子材料科学与工程,2012,28(7):124-127,131. Caifeng Li, Sanjiu Ying, Zhenggang Xiao. Microcelluar Foaming of Polypropylene/Nano-TiO2 Blends Using Supercritical CO2[J]. Polymer Materials Science & Engineering,2012,28(7):124-127,131.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2013-04-16
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司