PET薄膜挤出成型有限元模拟和阻流分析
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

TQ320.663

基金项目:


Finite Element Simulation of PET Film Extrusion and Analysis of Choked Flow
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    设计了厚度为0.12mm的聚对苯二甲酸乙二醇酯(PET)薄膜衣架式挤出流道,使用有限元软件模拟了聚合物熔体的流动规律,获得了流道内部的压力场、速度场和温度场的分布,分析了阻流设计对流场的影响。研究表明,流道结构对压力分布影响显著,对速度、温度分布影响不明显;流道阻流部分尺寸较小的改变,会引起流道内部熔体压力较大的变化,易导致挤出成型过程的不稳定,从而显著影响产品质量。此外,挤出流量对流场压力分布影响很小。

    Abstract:

    A coathanger type extrusion runner of polyethylene terephthalate(PET) film with thickness 0.12mm was designed.The polymer flow was simulated through finite element software,and the distribution of pressure,velocity and temperature field were obtained.The influence of polymer flow on the choked flow design was analyzed.The results show that the runner structure influences the pressure distribution significantly,influenles the distribution of speed and temperature slightly.If the size of choked flow structure of the runner is changed slightly,the pressure of the melt flow within the range of the runner will be changed markedly.So the size change of choked flow structure easily causes the process of extrusion instable,and significantly affects the product quality.Furthermore,the influence of melt flow rate on pressure distribution is insignificant.

    参考文献
    相似文献
    引证文献
引用本文

秦升学,杨迁,许星明. PET薄膜挤出成型有限元模拟和阻流分析[J].高分子材料科学与工程,2012,28(7):179-183. Shengxue Qin, Qian Yang, Xingming Xu. Finite Element Simulation of PET Film Extrusion and Analysis of Choked Flow[J]. Polymer Materials Science & Engineering,2012,28(7):179-183.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2013-04-16
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司