尼龙11/POE共混物的形态与力学性能
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

TB383.1

基金项目:

山西省自然科学基金资助项目(94012);山西省青年科技研究基金资助项目(200602011)


The Morphology and Mechanical Properties of PA11/POE Blends
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用动态力学分析(DMTA)和扫描电镜(SEM)等方法研究了相容剂乙烯辛烯共聚物接枝马来酸酐聚合物(POE-g-MAH)对尼龙11(PA11)共混体系力学性能及共混物形态的影响。结果表明,混合弹性体中m(POE-g-MAH)/m(POE)=2∶1时,PA11共混物的缺口冲击强度达到81.2 kJ/m2;共混物缺口冲击强度对MAH接枝率敏感;加入混合弹性体,共混体系分子间的作用力增大,损耗峰向高温方向移动,Tg升高;PA11与POE各个共混体系的β松弛峰高显著低于纯PA11的,加入POE和POE-g-MAH可有效降低PA11的吸水性;POE-g-MAH可显著改善PA11/POE共混材料的相容性,使分散相尺寸减小,分布均匀,且材料缺口冲击强度显著增大。

    Abstract:

    The effect of maleic anhydride grafted polyolefin elastomer(POE-g-MAH) as compatilizer on the mechanical properties and morphology of polyamide 11(PA11)/POE blends was investigated using dynamic mechanical analysis(DMTA) and scanning electron microscope(SEM).The results show that when the ratio of POE-g-MAH and POE in mixed elastomer is 2:1,the notched impact strength of PA11 blends reaches 81.2 kJ/m2.The notched impact strength of blends is sensitive to MAH grafted rate.When mixed elastomer is added into PA11,the intermolecular forces of blends system increase and the loss peaks move to the high temperature which results in higher Tg.The β relaxation peak of each blends of PA11 and POE is significantly lower than that of pure PA11,which illustrates that POE and POE-g-MAH can effectively reduce water absorptivity of PA11.POE-g-MAH can improve the miscibility between PA11 and POE,decrease the particle size of dispersion phase and obviously increase the notched impact strength of these blends.

    参考文献
    相似文献
    引证文献
引用本文

郭云霞,胡国胜,李迎春,杨云峰,王志强.尼龙11/POE共混物的形态与力学性能[J].高分子材料科学与工程,2012,28(8):43-46. Yunxia Guo, Guosheng Hu, Yingchun Li, Yunfeng Yang, Zhiqiang Wang. The Morphology and Mechanical Properties of PA11/POE Blends[J]. Polymer Materials Science & Engineering,2012,28(8):43-46.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2013-04-16
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司