聚丙烯酸酯微球塑性溶胶的流变性能
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

TQ317

基金项目:

中国林科院林业新技术所中央级公益性科研院所基本科研业务费专项资金(CAFINT2008K01)


Rheological Properties of Plasticized Polyacrylate Microspheres
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用旋转流变仪研究了三种不同粒径的聚丙烯酸酯微球在增塑剂邻苯二甲酸二异壬酯(DINP)中的流变性能和凝胶固化行为,并用原子力显微镜和透射电子显微镜表征了聚合物粒子的表面形貌和大小。流变测试结果表明,聚合物微球粒子尺寸越大,与DINP混合后体系黏度越小;并且混合体系随剪切速率增大黏度减小,呈假塑性流体行为;混合流体测定温度越高,体系黏度越小;增加聚合物所占的比例,体系黏度上升。振荡温度扫描显示,聚合物含量增加会使混合体系凝胶固化温度降低。

    Abstract:

    The rotational rheometer was used to investigate the rheological properties and gel curing behaviors of polyacrylate microsphares with different size in plasticizer 1,2-benzenedicarboxylic acid,diisononyl ester(DINP).Atomic force microscopy(AFM) and TEM were used to observe the morphology and sizes of these polymeric microspheres.Results of the rheological test suggest that with the size increasing,polymeric microspheres present a smaller viscosity in the mixture system.Additionally,the mixture fluid shows a pseudoplastic behavior in the process of shear rate accelerating.At the same time,when the temperature rises up or the proportion of polymer is dropping down,the viscosity of the mixture system decreases.Furthermore,the dynamic test indicates that higher proportion of the polymer could lower the gel curing temperature.

    参考文献
    相似文献
    引证文献
引用本文

程增会,张明明,王春鹏,储富祥.聚丙烯酸酯微球塑性溶胶的流变性能[J].高分子材料科学与工程,2012,28(9):95-99. Zenghui Cheng, Mingming Zhang, Chunpeng Wang, Fuxiang Chu. Rheological Properties of Plasticized Polyacrylate Microspheres[J]. Polymer Materials Science & Engineering,2012,28(9):95-99.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2013-04-16
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司