紫外光辐射交联硅橡胶及其性能
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


The Effects of Photocrosslinking on the Properties of Silicone Rubber
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    在光引发剂存在的条件下,采用紫外光对二氧化硅补强的硅橡胶进行了辐照交联。溶胀法测试结果表明,交联密度随光照时间的延长先增大,在8s后逐渐平稳。交联密度随光引发剂用量的增加先增加后减小,在0.6phr出现极大值。力学性能测试表明,紫外光辐照后硅橡胶的拉伸强度和断裂伸长率得到明显提高,分别达到6.1MPa和713%。差示扫描量热法(DSC)和动态力学性能(DMA)测试表明,经紫外光辐照后,硅橡胶中形成的交联网络抑制了分子链的运动,使结晶度从38.1%减小到33.9%,损耗峰对应的熔融转变温度从-31.21℃降低到-42.35℃。

    Abstract:

    The effects of photocrosslinking on the properties of silica reinforced silicone rubber in the presence of photoinitiator were studied. The results of solventswelling show that crosslink density increases with the UV irradiation time increasing until to 8s, and longer irradiation time has no effect on the crosslinking density. And the crosslinking density increases with the increase of the amount of photoinitiator and reaches the maximum at 0.6 phr. The mechanical tests show that tensile strength and elongation at break for silicone rubber increase evidently after UV irradiation, and reach maximum values of 6.1MPa and 713% respectively. The results from differential scanning calorimetry (DSC) and dynamic mechanical analysis (DMA) tests show that because the crosslinked network formed in silicone rubber restricts the mobility of silicone rubber molecular chains, after UV irradiation, the degree of crystallinity decreases from 38.1% to 33.9%, and the melting transition temperature corresponding to loss peak decreases from -31.21 ℃ to -42.35 ℃.

    参考文献
    相似文献
    引证文献
引用本文

李云辉,吕建平,徐志前,叶 磊,吴强华,瞿保钧.紫外光辐射交联硅橡胶及其性能[J].高分子材料科学与工程,2013,29(1):60-62. Yunhui Li, Jianping Lv, Zhiqian Xu, Lei Ye, Qianghua Wu, Baojun Qu. The Effects of Photocrosslinking on the Properties of Silicone Rubber[J]. Polymer Materials Science & Engineering,2013,29(1):60-62.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2013-09-23
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司