聚甲基丙烯酸十二酯的合成及吸油性能
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

海军工程大学自然科学基金资助项目(HGDQNJJ11003)


Preparation and Oil-Absorbting Properties of Poly(Lauryl Methacrylate)
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    以甲基丙烯酸十二酯(LMA)为单体,采用悬浮聚合法合成了聚甲基丙烯酸十二酯(PLMA),研究了该树脂对柴油、汽油、甲苯和四氯化碳的吸油性能。结果表明,树脂的吸油率随着时间的延长不断增大,最后达到最大吸油率Qmax,CCl4 的Qmax最大,为14.596g/g,达到Qmax的时间约为110min;柴油的的Qmax最小,为4.174g/g,而吸油速率则随着时间的延长呈现出不断降低的趋势。树脂对CCl4、甲苯和汽油的保油率不到90%,对柴油的保油率达到90%以上。树脂的缓释保油率与油品的种类关系较大,树脂对甲苯和四氯化碳的缓释能力较大。

    Abstract:

    The oil-absorpting resin of poly(lauryl methacrylate) (PLMA) was synthesized from lauryl methacrylate (LMA) monomer by suspension polymerization. The absorption behavior was studied. The results show that the oil absorption ratio of resin increases with time, and finally reaches the maximum(Qmax). Carbon tetrachoide has the largest Qmax of 14.596 g/g, and the time to reach Qmax is about 110 minutes. On the contrary, diesel oil has the lowest Qmax of 4.174 g/g. However, with time increasing, the rate of oil absorbing shows a downward trend. The oil-retaining ratio of carbon tetrachoide, gasoline and toluene is less than 90%, but that of diesel oil is more than 90%. Its oil controlled-release property is relevant with the type of the oil and performs better when being applied in toluene and carbon tetrachoide.

    参考文献
    相似文献
    引证文献
引用本文

魏 徵,刘鹏宇,王源升,李 瑜,余红伟.聚甲基丙烯酸十二酯的合成及吸油性能[J].高分子材料科学与工程,2013,29(2):5-8. Zheng Wei, Pengyu Liu, Yuansheng Wang, Yu Li, Hongwei Yu. Preparation and Oil-Absorbting Properties of Poly(Lauryl Methacrylate)[J]. Polymer Materials Science & Engineering,2013,29(2):5-8.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2013-09-24
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司