注塑工艺参数及流动方向对强度的影响
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Influence of Process Parameters and Flow Directionon Strength of Injection Molded Parts
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    对有承载要求的结构件,强度将直接影响到其使用性能。文中基于正交实验,研究了工艺参数对丁二烯—丙烯腈—苯乙烯三元共聚物(ABS)注塑制件不同方向上拉伸强度的影响。研究结果表明,沿分子取向方向上的强度要高于垂直取向方向上的强度;模具温度对垂直流动方向上拉伸强度的影响显著,强度随模具温度的升高而降低;熔体温度对平行流动方向上拉伸强度影响显著,随熔体温度的升高,强度降低,在垂直流动方向上熔体温度的影响规律相反。

    Abstract:

    The performance of the plastic parts was directly affected by its strength. The influence of process parameters on the tensile strength of different direction related to flow of acrylonitrile butadiene styrene terpolymer (ABS) injection molded parts was investigated based on the orthogonal experiments technique. The experiment results show the tensile strength along the molecular orientation is higher than that along the vertical direction.The influence of mold temperature on the tensile strength of the vertical direction was prominent, the tensile strength reduces with the increasing of the mold temperature. The influence of melt temperature on the tensile strength parallel flow direction was prominent, the tensile strength reduces with the melt temperature increasing ,and the influence of melt temperature on the tensile strength of vertical flow direction is contrary.

    参考文献
    相似文献
    引证文献
引用本文

路书芬,王利霞,申长雨.注塑工艺参数及流动方向对强度的影响[J].高分子材料科学与工程,2013,29(3):51-54. Shufen Lu, Lixia Wang, Changyu Shen. Influence of Process Parameters and Flow Directionon Strength of Injection Molded Parts[J]. Polymer Materials Science & Engineering,2013,29(3):51-54.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2013-10-08
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司