阴离子型萜烯基环氧树脂多元醇的交联反应动力学
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金资助项目(31100428,30972320)


Crosslinking Reaction Kinetics of Anionic Polyol from Terpene-Based Epoxy Resin
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用冷冻干燥和差示扫描量热法研究了以阴离子型萜烯基环氧树脂多元醇(T-PABA)水分散体与聚异氰酸酯组成的双组分水性聚氨酯体系的本体交联反应动力学。以Málek最大概然模型分析了实验数据,得到了交联反应动力学参数,建立了交联反应动力学方程。结果表明,以Málek最大概然法得到的双因子自催化模型(S-B模型)能较好地描述T-PABA交联体系的反应过程,在实验所考察的5K/min~20K/min升温速率范围内,其计算拟合动力学曲线与实验曲线吻合度较好。

    Abstract:

    The crosslinking reaction kinetics of a two-component waterborne polyurethane (2K-WPU) composed of an anionic polyol dispersion from terpene-based epoxy resin and a hexamethylene diisocyanate tripolymer were investigated using freeze-drying and differential scanning calorimetry (DSC) technique. The data fitting is implemented with Málek’s mechanism function method. The kinetic parameters of crosslinking reaction were determined by DSC kinetic analysis, and then the kinetic model was built. The results indicate that the crosslinking process of the reaction follows an autocatalytic reaction. The two parameter (m, n) autocatalytic model can well describe the crosslinking reaction process of 2K-WPU. The DSC curves derived from the experimental data show a good agreement with the theoretically calculation under 5 k/min~20 k/min heating rate.

    参考文献
    相似文献
    引证文献
引用本文

吴国民,孔振武,陈 健,霍淑平,刘贵锋,蒋剑春.阴离子型萜烯基环氧树脂多元醇的交联反应动力学[J].高分子材料科学与工程,2013,29(6):66-69. Guomin Wu, Zhenwu Kong, Jian Chen, Shuping Huo, Guifeng Liu, Jianchun Jiang. Crosslinking Reaction Kinetics of Anionic Polyol from Terpene-Based Epoxy Resin[J]. Polymer Materials Science & Engineering,2013,29(6):66-69.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2013-10-08
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司