聚合物微流控芯片的注射成型
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家重点基础研究发展计划(973计划)项目(2012CB025905)


Polymer Microfluidic Chip by Micro-Injection Molding
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    针对注塑成型微流控芯片过程中出现翘曲变形和微通道复制精度不高等缺陷,采用正交分析法,仿真优化了芯片厚度方向上的翘曲变形;基于翘曲优化结果,实验研究了微注射成型微流控芯片过程中模具温度、熔体温度和注射速度对微通道变形的影响。结果表明,保压时间和保压压力对微流控芯片的翘曲变形影响最大,而模具温度对微通道变形影响最为显著。采用优化的工艺参数,所成型的芯片微通道具有较高的复制度,无明显翘曲变形,可满足使用要求。

    Abstract:

    Aimed at improving the warping and insufficient replication accuracy of microfluidic chip in micro injection molding, orthogonal analysis method was introduced and the warping in the thickness direction was simulated. Based on the optimized result of warpage, the effects of mold temperature, melt temperature and injection speed on the morphology of micro channel were investigated. The results demonstrate that holding time and holding pressure have remarkable effects on the warping, and mold temperature have great effect on the deformation of micro-channel. The reasonable combination of process parameters were finally obtained, and the processed micro-channel of microfluidic chips show high replication fidelity and have no apparent warpage, which meets operation requirements.

    参考文献
    相似文献
    引证文献
引用本文

楚纯朋,蒋炳炎,周陆腾,聂胜钊.聚合物微流控芯片的注射成型[J].高分子材料科学与工程,2013,29(6):113-116. Chunpeng Chu, Bingyan Jiang, Luteng Zhou, Shengzhao Nie. Polymer Microfluidic Chip by Micro-Injection Molding[J]. Polymer Materials Science & Engineering,2013,29(6):113-116.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2013-10-08
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司