聚碳酸丁二醇酯的静电纺丝制备及细胞相容性
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


The Electrospinning and Its Cytocompatibility of Poly(Butylene Carbonate)
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用静电纺制备了聚碳酸丁二醇酯(PBC)纤维膜,研究了工艺条件对纤维膜形貌的影响及纤维膜的亲水性和细胞相容性。结果表明,溶剂对纤维膜形貌具有重要影响;在PBC质量分数为22%~28%,电压-距离比为20kV/20cm,湿度在20%~50%所制得的纤维膜具有良好的表面形貌;PBC纤维膜的亲水性优于聚己内酯(PCL);PBC纤维膜的细胞铺展和细胞增殖结果与PCL差异较小。

    Abstract:

    In this paper, poly(butylene-carbonate) nanofiber mat was prepared by electrospinning. The influence of technological conditions on the morphology and some properties, such as hydrophily and cellular biocompatibility of the fiber mat were studied. The results show that solvents have an important effect on the morphology. Under the conditions as follow: PBC mass fraction of 22%~28%, voltage/distance ratio of 20kV/20cm, and humidity between 20%~50%, fibers with a good appearance would be generated. The contact angle test shows that PBC nanofibers have the better hydrophily than PCL. At the same time, the results about the cellular biocompatibility of PBC nanofiber mat show that cells can well sprawl on both mats and there are no significant differences after 7 days of proliferation.

    参考文献
    相似文献
    引证文献
引用本文

邵成华,沈新元,杨 庆,夏 阳,姚 菁,章非敏,顾晓华.聚碳酸丁二醇酯的静电纺丝制备及细胞相容性[J].高分子材料科学与工程,2013,29(6):137-140. Chenghua Shao, Xinyuan Shen, Qing Yang, Yang Xia, Jing Yao, Feimin Zhang, Xiaohua Gu. The Electrospinning and Its Cytocompatibility of Poly(Butylene Carbonate)[J]. Polymer Materials Science & Engineering,2013,29(6):137-140.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2013-10-08
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司