纳微多级孔ACF/PTFE/PEEK 复合材料的制备及发汗式减摩耐磨性能
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家青年拔尖人才(2012);国家自然科学基金资助项目(50903010,51175066);全国优博专项(201164);省新世纪优秀人才(1251-NCET-007)


Preparation of Nano-Micron Hierarchical Porous ACF/PTFE/PEEK Composites and Its Sweating Friction and Wear Properties
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用模压-滤取和高温真空熔渍工艺及纳微多尺度协同设计制备了自身发汗式多级孔活性炭纤维(ACF)/聚四氟乙烯(PTFE)/聚醚醚酮(PEEK)复合材料。考察了ACF、微米级造孔剂NaCl含量及载荷对其摩擦学性能的影响。结果表明,当介孔ACF总质量分数为8%、NaCl总质量分数为30%所得多级孔ACF/PTFE/PEEK 复合材料摩擦系数和磨损率最低,载荷为200N时,摩擦系数、磨损率分别为0.0259、5.26×10-16 m3/N·m,较经典炭纤维增强PEEK 复合材料摩擦系数减少86%,耐磨性提高了16倍。研究表明,介孔ACF在材料内部形成了贯通型三维网络毛细管道,如同人体汗腺机制,使微米级孔中储存的润滑脂在载荷和温度的作用下能在摩擦面上形成较好的润滑油膜,并且ACF能起到部分骨架支撑作用,因而ACF在材料中起到很好的减摩耐磨作用。

    Abstract:

    The self-sweating lubrication wear resistance porous activated carbon fiber (ACF)/polytetrafluoroethylene (PTFE)/polyetheretherketone (PEEK) composites were prepared by molded leaching and high temperature vacuum melting technologies. The effects of ACF content, micronpore forming agent NaCl content and load on the tribological properties of composites were investigated. The results show that the porous ACF/PTFE/PEEK composite material has the lowest friction coefficient and wear rate when 8% ACF and 30% NaCl were added. When the load is 200N, comparing with those of carbon fiber(CF)/PEEK composite, the friction coefficient and wear rate of porous ACF/PTFE/PEEK composite decrease 86% and 16 times, respectively. The results also show that pore forming agent NaCl formed a large number of micron pores, and lubricant grease can be stored in the three-dimensional networks built of the porous structure and mesoporous ACF as the network skeleton. The stored grease can form a more stable, continuous lubricating oil film on the sliding surface under the conjunct effect of the load and temperature, which can benefit the wear resistance of porous ACF/PTFE/PEEK composites.

    参考文献
    相似文献
    引证文献
引用本文

汪怀远,林 珊,王宝辉,杨淑慧,闫 雷,王 超.纳微多级孔ACF/PTFE/PEEK 复合材料的制备及发汗式减摩耐磨性能[J].高分子材料科学与工程,2013,29(10):128-132. Huaiyuan Wang, Shan Lin, Baohui Wang, Shuhui Yang, Lei Yan, Chao Wang. Preparation of Nano-Micron Hierarchical Porous ACF/PTFE/PEEK Composites and Its Sweating Friction and Wear Properties[J]. Polymer Materials Science & Engineering,2013,29(10):128-132.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2013-11-11
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司