热流道计算机辅助工程(CAE)在洗衣机面板成型中的应用
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Application of Hot Runner Computer Aided Engineering (CAE) in Washing Machine Panel Molding
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    热流道由于其多方面的优势而越来越被用于塑料的注射成型。文中以某款洗衣机面板为例,利用Moldflow 软件对普通热流道和针阀式顺序注塑过程进行了优化模拟。通过对两者成型结果的定性分析和比较,可以得出,后者成型过程中,需要的最大注射压力和最大锁模力均小于前者成型的值,而制件的气穴和熔接痕的位置和数量明显优于前者成型的效果,制件总体质量和力学性能得到明显提高。同时也提出了顺序注塑模拟中应注意的问题。

    Abstract:

    Because of its many advantages, the hot runner was more commonly used in plastic injection molding. In this paper, a washing machine panel was taken for an example, the ordinary hot runner and needle sequential injection molding process were simulated using the Moldflow software. According to the qualitative analysis and comparison to the molding results, it can be seen that the latter results of the molding process, the largest injection pressure and maximum clamping force are less than the former molding values, while the location and quantity of air traps and weld lines are superior to those of the former, the overall quality and mechanical properties are improved obviously. At the same time, the problems that should be paid attention were pointed out about the simulation of sequential injection molding.

    参考文献
    相似文献
    引证文献
引用本文

沈洪雷,刘 峰.热流道计算机辅助工程(CAE)在洗衣机面板成型中的应用[J].高分子材料科学与工程,2013,29(10):175-178. Honglei Shen, Feng Liu. Application of Hot Runner Computer Aided Engineering (CAE) in Washing Machine Panel Molding[J]. Polymer Materials Science & Engineering,2013,29(10):175-178.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2013-11-11
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司