溶剂热法合成含异氰酸酯基的聚丙烯大分子相容剂
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金资助项目(51103135);浙江省自然科学基金资助项目(Y4100534,Y4110360)


Solvothermal Process for Synthesis of Macromolecules Compatibilizer ofPolypropylene Containing Isocyanate Ester Groups
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用溶剂热法将含有异氰酸根官能团的单体3-异丙烯基-α,α′-二甲基苄基-异氰酸酯(TMI)接枝到聚丙烯(PP)上,利用红外光谱(FI-IR)、动态流变和差示扫描量热法(DSC)研究了TMI、过氧化二异丙苯(DCP)和苯乙烯(St)用量对PP接枝率、流变性能和熔融与结晶行为的影响。结果表明,TMI单体成功接枝到PP链上;St能有效提高TMI的接枝率和抑制PP的降解;PP接枝率随TMI、St用量的增加先增大后减小,随DCP用量的增加先增大而后趋于稳定。随TMI、St用量的增加,PP黏度不断增大,而DCP用量的增加则会降低PP的黏度。改性后PP相比于纯PP结晶温度有所升高,熔融温度有所降低。

    Abstract:

    3-isopropenyl-α,α′-dimethylbenzene isocyanate (TMI) was grafted onto polypropylene (PP) by solvothermal method. The effect of the content of TMI, dicumyl peroxyide (DCP) and styrene (St) on the grafting degree, rheological properties, melting and crystallization temperature of PP was studied by Fourier transform infrared spectroscopy (FT-IR), rotational rheometer and differential scanning calorimetry (DSC). The results show that TMI was successfully grafted onto PP backbone. St could greatly improve the TMI grafting degree of PP and reduce the degradation of PP. As the contents of TMI and St increasing, the grafting degree of PP first increases and then decreases. The grafting degree of PP increases with the increase of DCP content at first, and then tends to be stable. With the increase of TMI and St content, the viscosity of PP increases, while increasing the DCP content will reduce the viscosity of PP. Compared with pure PP, modified PP has higher crystallization temperature and lower melting temperature.

    参考文献
    相似文献
    引证文献
引用本文

李浩, 朱士洋, 张先明, 徐俊杰, 唐红艳, 冯连芳.溶剂热法合成含异氰酸酯基的聚丙烯大分子相容剂[J].高分子材料科学与工程,2013,29(11):19-23. Hao Li, Shiyang Zhu, Xianming Zhang, Junjie Xu, Hongyan Tang, Lianfang Feng. Solvothermal Process for Synthesis of Macromolecules Compatibilizer ofPolypropylene Containing Isocyanate Ester Groups[J]. Polymer Materials Science & Engineering,2013,29(11):19-23.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2013-11-11
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司