接枝聚苯醚/聚酰胺66共混物的制备与结构性能
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家科技支撑计划(2012BADB01)资助;吉林省科技发展计划项目(20115005)资助;吉林省与中科院合作项目(2011CJT0013)资助


Preparation, Structure and Properties of Graft Polyphenylene Oxide/Polyamide 66 Blends
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    将聚苯醚接枝马来酸酐(PPO-g-MAH)与聚酰胺66(PA66)通过熔融挤出制备了PPO-g-MAH/PA66共混物,利用SEM、DSC、电子拉力机、旋转流变仪对共混物的结构及性能进行了研究。结果表明,共混物中PA66相的熔融温度逐渐升高,两组分熔融峰内移程度增大。发现随PPO-g-MAH 的质量份增加,共混物的吸水率降低,分散相粒子更加细小、均匀。与质量比30/70的PPO/PA66 共混物比,相同质量比的PPO-g-AH/PA66的拉伸强度和冲击强度分别是其1.3倍和1.2倍。PPO-g-MAH/PA66的复合黏度和储能模量均大于PPO/PA66,PPO-g-MAH 与PA66具有良好的相容性。

    Abstract:

    Maleic anhydride (MAH) grafted polyphenylene oxide (PPO) (PPO-g-MAH)/PA66 blends were prepared by reactive extrusion. The structure and properties of blends were investigated by SEM, DSC, mechanical tester and rotational rheometer. DSC results indicate that the melt temperature of PA66 increases, the molten peaks of two components of PPO and PA66 move more close in PPO-g-MAH/PA66 blends when the content of PPO-g-MAH increases. It was found that water absorption of PPO-g-MAH/PA66 blends decreases with the content of PPO-g-MAH increasing. Morphologies of PPO-g-MAH/PA66 blends show that the dispersed phase becomes more fine and uniform. The tensile strength and impact strength of PPO-g-MAH/PA66 blends are 1.3 times and 1.2 times of those of PPO/PA66 blends, respectively. The complex viscosity and storage modulus of PPO-g-MAH/PA66 blends are higher than those of PPO/PA66 blends, indicating that compatibility of PPO-g-MAH and PA66 is improved.

    参考文献
    相似文献
    引证文献
引用本文

李文斐, 姚占海, 谢磊, 赵瑞雪, 李莉霞.接枝聚苯醚/聚酰胺66共混物的制备与结构性能[J].高分子材料科学与工程,2013,29(11):132-135. Wenfei Li, Zhanhai Yao, Lei Xie, Ruixue Zhao, Lixia Li. Preparation, Structure and Properties of Graft Polyphenylene Oxide/Polyamide 66 Blends[J]. Polymer Materials Science & Engineering,2013,29(11):132-135.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2013-11-11
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司