动态固化环氧树脂对芳纶/天然橡胶复合材料界面的改性
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

贵州省橡胶重大专项(2013)


Interface Modification of Aramid Fiber/Natural Rubber Composites with Dynamically Cured Epoxy
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    在经磷酸(PA)处理的芳纶(AF)表面上涂覆环氧树脂(EP)和固化剂(2E4MZ),用极性端基液体橡胶(LIR)作为EP与天然橡胶(NR)的相容剂,改善AF与NR的界面,并用母炼胶法制备了AF/NR复合材料。通过与NR和单一用磷酸处理AF的复合材料的性能对比发现,AF经过EP和2E4MZ改性后,AF/NR 复合材料的硫化速度和交联程度均提高;拉伸强度、撕裂强度和300% 定伸应力都显著增强,且当m(EP)/m(AF)为7/100时最佳。动态力学性能测试(DMA)结果表明,EP/2E4MZ处理AF的天然胶具有更高的储能模量和损耗模量;扫描电镜(SEM)分析表明,AF/NR的拉伸断面粗糙,EP和2E4MZ能改善AF与NR的界面粘接。

    Abstract:

    Aramid fiber(AF) was modified with epoxy resin(EP) and curing agent 2-ethyl-4-methylimidazole(2E4MZ) via surface coating on the basis of the treatment with phosphorous acid solution. Liquid isoprene rubber(LIR) was regard as compatibilizer between EP and NR. AF/NR composites were prepared through masterbatch method. The deep-going modified AF not only accelerated the vulcanization of NR composites, but also enhanced the mechanical properties of AF/NR composites such as the tensile strength and the tear strength. When m(EP)/m(AF) is 7/100, comprehensive properties of vulcanized AF/NR are the best. The results of dynamic mechanical analysis (DMA) reveal that AF/NR composites have higher storage modulus and loss modulus after AF was treated with EP and 2E4MZ. Scanning electron microscopy (SEM) photos show that the tensile fracture of AF/NR composites becomes rough, implying that the bonding strength in interface is improved with the addition of EP and 2E4MZ.

    参考文献
    相似文献
    引证文献
引用本文

杨诗润,罗 筑,吴晓宇,夏忠林,于 杰.动态固化环氧树脂对芳纶/天然橡胶复合材料界面的改性[J].高分子材料科学与工程,2013,29(12):77-81. Shirun Yang, Zhu Luo, Xiaoyu Wu, Zhonglin Xia, Jie Yu. Interface Modification of Aramid Fiber/Natural Rubber Composites with Dynamically Cured Epoxy[J]. Polymer Materials Science & Engineering,2013,29(12):77-81.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2013-12-06
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司