压力对PET/PA6共聚物流变行为的影响
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家“十二五”科技支撑计划资助项目(2011BAE05B00)


Effect of Pressure on Rheological Behavior of PET/PA6 Copolymer
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    利用毛细管流变仪及反向压力腔组件在毛细管出口压力高于常压条件下,对聚对苯二甲酸乙二醇酯/尼龙6(PET/PA6)共聚物熔体的流变行为进行了研究。结果表明,在恒定剪切速率下,随着毛细管内平均压力(pm )的增大,剪切黏度逐渐增大,在实验温度为300℃ 和剪切速率为108s-1时,剪切黏度从10MPa 的130Pa·s增到大50MPa 的215Pa·s;随着剪切速率的增大或温度的升高,pm 对剪切黏度的影响均逐渐减小;同时压力系数随着剪切速率的增大和温度的升高而呈下降趋势。

    Abstract:

    The rheological behavior of polyethylene terephthalate/polyamides 6(PET/PA6) copolymer melt was investigated through the capillary rheometer and counter pressure chamber when the pressure at the outlet of capillary was higher than normal pressure. The results show that when the shear rate is a fixed constant, the shear viscosity of copolymer increases with the increase of average capillary pressure, and the shear viscosity increases from 130 Pa·s to 215 Pa·s along with pm increasing from 10MPa to 50 MPa while the temperature is 300 ℃ and the shear rate is 108 s-1. It is found that effect of the average capillary pressure on the shear rate decreases with the increase of the shear rate or the temperature; the pressure coefficient shows a downward trend with the increase of the shear rate and the temperature.

    参考文献
    相似文献
    引证文献
引用本文

郭增革,李 健,程博闻,张 斌,唐兵兵,李 鑫.压力对PET/PA6共聚物流变行为的影响[J].高分子材料科学与工程,2014,30(1):53-57. Zengge Guo, Jian Li, Bowen Cheng, Bin Zhang, Bingbing Tang, Xin Li. Effect of Pressure on Rheological Behavior of PET/PA6 Copolymer[J]. Polymer Materials Science & Engineering,2014,30(1):53-57.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2014-01-07
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司