静电纺丝制备聚乙烯醇/再生柞蚕丝素蛋白复合纳米纤维
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

福建省科技厅重点资助项目(2010Y0020)


Preparation of Polyvinyl Alcohol/Regenerated Wild Antheraea Pernyi Silk Fibroin Composite Nanofibers Through Electrospinning
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    将聚乙烯醇(PVA)与再生柞蚕丝素蛋白(RWSF)共混,通过静电纺丝技术制备了PVA/RWSF复合纳米纤维,在保持材料降解性能和力学强度不变的前提下,获得了具有生物活性的表面。应用正交法优选出PVA/RWSF复合纳米纤维的最佳制备工艺参数。扫描电镜观察到,各组电纺膜中纤维的形貌较好,不同参数条件下纤维的直径和均匀程度有较大差别;方差分析表明,静电纺丝过程中纺丝液浓度、PVA/RWSF质量比和纺丝电压对纤维均匀性的影响显著;结合后期验证性实验确定PVA/RWSF复合纳米纤维最佳电纺参数为电纺液浓度0.09g/mL、PVA/RWSF质量比90/10、纺丝电压18kV、推进速度1.5mL/h、接收距离14cm,此时制备的纤维均一、纤细,重复性好。

    Abstract:

    Plyvinyl alcohol (PVA) was blended with the regenerated wild antheraea pernyi silk fibroin (RWSF) to prepare PVA/RWSF composite nanofiber through electrospinning technology. On the premise of maintaining the mechanical strength and the degradation property of the material, the biologically active surface was got. The best preparation process of PVA/RWSF composite nanofibers was selected by the orthogonal design. The results show that, the morphology of the fiber is good, the diameter and the uniformity of the fiber are quite different under the different conditions. Analysis of variance shows that the spinning solution concentration, mass ratio of PVA/RWSF and spinning voltage have significant impact on the uniformity of fibers during the electrospinning process. The best electro-spinning parameters: spinning solution concentration 0.09 g/mL, mass ratio of PVA / RWSF 90/10, spinning voltage 18kV, the advancing speed 1.5 mL/h, the receiving distance 14cm. The fibers are uniform, slim with good repeatability.

    参考文献
    相似文献
    引证文献
引用本文

谭敬豪,朱 颖,周志华,李 敏.静电纺丝制备聚乙烯醇/再生柞蚕丝素蛋白复合纳米纤维[J].高分子材料科学与工程,2014,30(1):157-161. Jinghao Tan, Ying Zhu, Zhihua Zhou, Min Li. Preparation of Polyvinyl Alcohol/Regenerated Wild Antheraea Pernyi Silk Fibroin Composite Nanofibers Through Electrospinning[J]. Polymer Materials Science & Engineering,2014,30(1):157-161.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2014-01-07
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司