硅灰石填充改性尼龙1212复合材料的制备
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家“863”项目(2011AA02A204-03);河南省创新人才计划(124200510011)资助项目


Preparation of Nylon 1212/Wollastonite Composites
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    利用偶联剂对硅灰石表面进行处理,制备了硅灰石粉填充改性尼龙1212复合材料。研究了偶联剂用量和硅灰石含量对复合材料力学性能的影响,分析了硅灰石填充对复合材料热变形温度和热膨胀系数的影响。结果表明,加入质量分数1.0%的KH-550型硅烷偶联剂,当硅灰石的质量分数为40%时,复合材料的拉伸强度、弯曲强度较尼龙1212提高了11%和64%,冲击强度基本保持不变。同时,复合材料的热变形温度提高了93%,热膨胀系数有明显的降低,吸水率下降了55%,材料尺寸稳定性有明显提高。

    Abstract:

    Nylon 1212/wollastonite composites were prepared. First the wollastonite was modified with coupling agent, and then was added into nylon 1212 to get nylon 1212/wollastonite composites. The influence of the dosage of coupling agent and the wollastonite content on properties of composites was studied. The results show that compared with those of nylon 1212, the tensile strength, the bending strength and the bending modulus of the composites are greatly improved along with increase of the wollastonite content. And the thermal deformation temperature increases significantly, while a slight decrease in the impact strength. A big drop both in the thermal expansion coefficients and water absorption is found.

    参考文献
    相似文献
    引证文献
引用本文

付 鹏,崔 吉吉,于艺博,刘民英,许建稳,赵清香.硅灰石填充改性尼龙1212复合材料的制备[J].高分子材料科学与工程,2014,30(4):154-157. Peng Fu, Zhe Cui, Yibo Yu, Minying Liu, Jianwen Xu, Qingxiang Zhao. Preparation of Nylon 1212/Wollastonite Composites[J]. Polymer Materials Science & Engineering,2014,30(4):154-157.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2014-04-18
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司