磷钨酸表面处理对燃料电池质子交换膜热稳定性的影响
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

安徽省国际科技合作计划资助项目(06088018);淮南市科技计划资助项目(2011A07923)


Effect of Tungstophosphoric Acid Surface Treatment on the Thermal Stability of Proton Exchange Membrane for Fuel Cell
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    研究了磷钨酸掺杂改性后质子交换膜的热稳定性及热降解动力学,利用热重分析在氮气气氛下和升温速率分别为5℃、20℃和30℃时,采用Kissinger、Flynn-Wall-Ozawa、Friedman和Starink方法对磷钨酸改性后的非等温动力学数据进行了分析。热失重曲线显示磷钨酸改性后质子交换膜分解率达到5%和10%时,最低热降解温度分别为173.6 ℃和284.8℃。采用不同方法的计算结果显示,改性后膜分解反应受D2机理控制,表观活化能约为163.74kJ/mol。改性前后膜的电导率(σ)分别为8.34×10-7S/cm 及2.57×10-5S/cm。

    Abstract:

    The thermal stability and thermal degradation kinetics of proton-exchange membrane were investigated, when it was doped and modified by tungstophosphoric acid. Non-isothermal kinetic data of modified membrane were analyzed by the thermogravimetry analysis and the Kissinger,Flynn-Wall-Ozawa,Friedman and Starink method, under the conditions of nitrogen atomosphere and heating rate of 5 ℃, 20 ℃ and 30 ℃. TG-DTG curves show that at the conversion rate of 5% and 10%, the lowest temperature of the thermal degradation is 173.6 ℃ and 284.8 ℃, respectively. The results calculated by various method indicate that the average value of apparent activation energy of modified membrane is about 163.74 kJ/mol. The decomposition reaction of modified membrane is controlled by D2 mechanism, the conductivity of membrane before and after modified respectively is 8.34×10-7 S/cm and 2.57×10-5 S/cm.

    参考文献
    相似文献
    引证文献
引用本文

鲁伊恒,魏 风,吕玉卫,马双春,李寒旭,陈明强.磷钨酸表面处理对燃料电池质子交换膜热稳定性的影响[J].高分子材料科学与工程,2014,30(5):67-71. Yiheng Lu, Feng Wei, Yuwei Lv, Shuangchun Ma, Hanxu Li, Mingqiang Chen. Effect of Tungstophosphoric Acid Surface Treatment on the Thermal Stability of Proton Exchange Membrane for Fuel Cell[J]. Polymer Materials Science & Engineering,2014,30(5):67-71.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2014-05-15
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司