丙烯酸酯类共聚物与纳米CaCO3 协同改性聚碳酸酯/丙烯腈-丁二烯-苯乙烯三元共聚物合金
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Synergistic Effect of Acrylic Resin and Nano-CaCO3 on Polycarbonate/Acrylonitrile-Butadiene-Styrene Copolymer Alloy
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    研究了聚碳酸酯(PC)/丙烯腈-丁二烯-苯乙烯三元共聚物(ABS)组分配比对合金性能的影响;丙烯酸酯类共聚物(ACR)、纳米CaCO3 单独使用与复配对PC/ABS合金性能的影响,并采用电子扫描电镜观察其微观结构。结果发现,随着PC用量的增加,冲击强度与断裂拉伸应变先降后升再降,PC质量分数在50%~60%,出现极大值,拉伸强度先降后升再降再升;随着ACR用量的增加,冲击强度与断裂拉伸应变先升后降,ACR质量分数在5%左右时,出现极大值,拉伸强度呈下降趋势;随着纳米CaCO3 用量的增加,冲击强度与拉伸强度先升后降,断裂拉伸应变急剧下降,质量分数在4%左右时,综合性能优异;ACR与纳米CaCO3 复配使用时,材料性能明显优于单独使用,当纳米CaCO3 质量分数为4%,ACR质量分数为5%时,拉伸强度可达59MPa,冲击强度可达108kJ/m2;通过扫描电镜照片发现,ACR改善了纳米CaCO3 的界面结合与分散状况。

    Abstract:

    Effect of the mass ratio of polycarbonate(PC) and acrylonitrile-butadiene-styrene copolymer(ABS), and synergistic effect of acrylic resin (ACR) and nano-CaCO3 on PC/ABS alloy properties were studied. The low temperature brittle facture surface was observed by SEM. It is found that with increase of the PC amount, the notched impact strength and the elongation at break increase first, then decrease and finally increase. When the mass fraction of PC is 50%~60%, the maximum value is got. The tensile strength rises up after a decline, and then rises up after a decline. With increase of the ACR amount, the notched impact strength and the elongation at break first increase and then decrease. When the mass fraction of ACR is 5%, the maximum value is got and the tensile strength decreases. With increase of the nano-CaCO3 amount, the notched impact strength and the tensile strength first go up and then down, the elongation at break decreases sharply. When the mass ratio of nano-CaCO3 is 4%, the comprehensive performance is excellent. When ACR and nano-CaCO3 were added together, properties of PC/ABS alloy is better than used alone. When the mass fraction of ACR and nano-CaCO3 is 5% and 4% respectively, the tensile strength reaches 59 MPa, notched impact strength 108 kJ/m2. The scanning electron microscope images show that interface bonding and dispersion of nano-CaCO3 are improved by adding ACR.

    参考文献
    相似文献
    引证文献
引用本文

张 宁,郭 强.丙烯酸酯类共聚物与纳米CaCO3 协同改性聚碳酸酯/丙烯腈-丁二烯-苯乙烯三元共聚物合金[J].高分子材料科学与工程,2014,30(5):81-86. Ning Zhang, Qiang Guo. Synergistic Effect of Acrylic Resin and Nano-CaCO3 on Polycarbonate/Acrylonitrile-Butadiene-Styrene Copolymer Alloy[J]. Polymer Materials Science & Engineering,2014,30(5):81-86.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2014-05-15
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司