高抗弯聚丙烯/有机化锂皂石复合材料的制备与性能
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

湖北省教育厅科学技术研究计划青年项目(Q20131510);武汉工程大学科学研究基金项目(11102041)


Preparation of Polypropylene /Organic-Laponite Composites with High Bending Modulus
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用十六烷基三甲基溴化铵(CTAB)对锂皂石(Laponite)进行修饰,得到有机化锂皂石。采用聚丙烯接枝马来酸酐(PP-g-MAH)作为增容剂,制备了一种具有高抗弯模量和高断裂伸长率的聚丙烯/有机化锂皂石复合材料,考察了有机化锂皂石对复合材料性能的影响。结果表明,当有机化锂皂石的用量增加时,复合材料的弯曲模量增加,断裂伸长率则先增加后降低。当有机化锂皂石质量分数仅为1%时,复合材料弯曲模量达到1230 MPa,相比纯PP提高约35%;复合材料的断裂伸长率达到700%,相比于纯PP,提高约25%。扫描电子显微镜结果显示,有机化锂皂石在聚丙烯基体中分布均匀,粒径在0.5μm~1μm 之间,与聚丙烯基体结合良好。

    Abstract:

    Organic-laponite was synthesized using cetyl trimethyl ammonium bromide(CTAB) as modifier and polypropylene (PP)/organic-Laponite composites with high flexural modulus and high elongation at break were prepared by melt blending using maleic anhydride grafted polypropylene(PP-g-MAH) as compatibilizer. The effect of laponite and PP-g-MAH content on properties of composites was discussed. The results show that the flexural modulus of the composites increases and nevertheless the elongation at break first increases and then decreases when the content of the organic-laponite increases. When the content of organic-laponite is only 1%, the bending modulus of the composite reaches 1230 MPa and increases by about 35% compared with that of PP. Furthermore, the elongation at break of the composite reaches 700% and increases by about 25% compared with that of PP. The results of scanning electron microscope(SEM) show that organic-laponite uniformly disperses in the polymer matrix and the particle diameter ranges from 0.5 μm to 1 μm and organic-laponite is combined well with PP.

    参考文献
    相似文献
    引证文献
引用本文

熊丽君,钱鑫昌,张 兵,黄 萌,彭永利.高抗弯聚丙烯/有机化锂皂石复合材料的制备与性能[J].高分子材料科学与工程,2014,30(6):152-155. Lijun Xiong, Xinchang Qian, Bing Zhang, Meng Huang, Yongli Peng. Preparation of Polypropylene /Organic-Laponite Composites with High Bending Modulus[J]. Polymer Materials Science & Engineering,2014,30(6):152-155.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2014-06-16
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司