高强度聚N,N-二甲基丙烯酰胺/氧化石墨烯复合水凝胶的制备
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金资助项目(50573016)


Preparation of Poly(N,N-Dimethy-Lacrylamide)/Graphene Oxide Nanocomposite Hydrogel with High Mechanical Strength
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    以N,N-二甲基丙烯酰胺(DMA)为单体,N,N-胱胺二丙烯酰胺(CBA)为交联剂,在氧化石墨烯(GO)水分散液中进行自由基原位聚合,制备了高强度PDMA/GO 复合水凝胶,研究了GO 和交联剂CBA的含量对复合水凝胶性能的影响。结果表明,复合水凝胶的热稳定性、拉伸强度和压缩强度随GO 和CBA含量的增加而增加,其平衡溶胀比随GO 含量的增加而减小。利用CBA的二硫键可以还原断裂的性质,通过热重分析测定了PDMA 在GO 表面的接枝效率。结果表明,GO 不是简单共混在水凝胶中,而是起到了交联剂的作用,使得复合水凝胶具有优良的拉伸强度和压缩强度。

    Abstract:

    Nanocomposite hydrogels with high mechanical strength were prepared by in situ polymerization in graphene oxide aqueous suspension, using N,N-dimethylacrylamide(DMA)as monomer and N,N-cystaminebisacrylamide (CBA) as crosslinker. The effect of the content of graphene oxide (GO) and CBA on the properties of the hydrogel was investigated. It is found that tensile strength, compressive strength and thermal properties of the hydrogel increase, while the equilibrium swelling ratio of the hydrogel decreases with increasing the content of GO or CBA. The grafting efficiency of PDMA on the GO surface was measured by TGA, for the disulfide bond of the crosslinker, i. e., CBA can be fractured by reducing agent. The result shows that GO was not simply physically blended in the composite hydrogel, in fact, it acts as crosslinking agent, so the PDMA/GO nanocomposite hydrogel has excellent tensile strength and compressive strength.

    参考文献
    相似文献
    引证文献
引用本文

李明会,王平华,刘春华,唐龙祥.高强度聚N, N-二甲基丙烯酰胺/氧化石墨烯复合水凝胶的制备[J].高分子材料科学与工程,2014,30(8):7-11. Minghui Li, Pinghua Wang, Chunhua Liu, Longxiang Tang. Preparation of Poly(N, N-Dimethy-Lacrylamide)/Graphene Oxide Nanocomposite Hydrogel with High Mechanical Strength[J]. Polymer Materials Science & Engineering,2014,30(8):7-11.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2014-08-20
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司