硅烷偶联剂对高密度聚乙烯薄膜/杨木胶合板性能的影响
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家林业公益性行业科研专项重大项目(201004004)


Effects of Silane Agent on Mechanical Properties of HDPE Film/Poplar Plywood
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用硅烷偶联剂乙烯基三甲氧基硅烷(A-171)对杨木单板进行预处理,然后与高密度聚乙烯(HDPE)薄膜复合制备胶合板。研究了A-171对板材物理力学性能的影响,利用红外光谱、X射线光电子能谱及扫描电镜探讨了界面增容的机理。结果表明,经过A-171处理后,板材的胶合强度和耐水性都有所改善,当偶联剂用量为2%时处理效果最好,胶合强度达到1.8MPa,比未处理材的胶合强度增加128%,木破率也由10% 提高到99%。胶合板的24h吸水率(WA)和吸水厚度膨胀率(TS)分别降低了28%和42%。通过X射线光电子能谱、红外光谱和扫描电镜分析可知,A-171成功在杨木单板表面发生了接枝反应,有效地改善了单板与HDPE的界面相容性。

    Abstract:

    Poplar veneers pretreated by silane agent vinyltrimethoxysilane (A-171) were composited with high density polyethylene (HDPE) film to prepare wood-plastic plywood. The treating effects on physical-mechanical properties of wood-plastic plywood were investigated. The interaction of treated veneer and A-171 was investigated by FT-IR, XPS and SEM. The results show that the shear strength and water-resistance are both positively affected by the silane treatment. When the silane content is up to 2%, the shear strength reaches 1.8 MPa which is 128% higher than that of the untreated panels, and the wood failure increases from 10% to 99%. The pretreatment also causes a reduction of water absorption and thickness swelling by 28% and 42% respectively. Silane A-171 was successfully deposited and grafted on veneer and improves the interfacial compatibility of veneer and HDPE from the analyses of XPS, FTIR and SEM.

    参考文献
    相似文献
    引证文献
引用本文

方 露,常 亮,郭文静,陈勇平,王 正.硅烷偶联剂对高密度聚乙烯薄膜/杨木胶合板性能的影响[J].高分子材料科学与工程,2014,30(10):78-81. Lu Fang, Liang Chang, Wenjing Guo, Yongping Chen, Zheng Wang. Effects of Silane Agent on Mechanical Properties of HDPE Film/Poplar Plywood[J]. Polymer Materials Science & Engineering,2014,30(10):78-81.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2014-10-17
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司