PBT/(POE/LLDPE)-g-GMA 共混物的力学性能与形态结构
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Mechanical Properties and Morphology of PBT / (POE/LLDPE)-Graft-GMA Blends
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用双螺杆挤出机将甲基丙烯酸缩水甘油酯(GMA)同时接枝到乙烯-辛烯共聚物(POE)和线性低密度聚乙烯LLDPE上,而后将接枝产物与聚对苯二甲酸丁二醇酯(PBT)反应性共混,通过改变POE/LLDPE比例确立了PBT/(POE/LLDPE)-g-GMA共混物分散相的最佳组成。以此为基础考察了GMA加入量对共混物的力学性能、流变行为及相形态的影响,并对共混物的形变机理进行了研究。实验结果表明,POE/LLDPE比例为50/50时冲击强度最大,在此组成下共混物的冲击强度随着GMA加入量的增加而呈现先增大后减小的趋势,并在GMA 加入量(GMA/(POE+LLDPE))为5%时达到最大值;体系黏度随GMA加入量的增加而增大,过量的GMA会导致严重的交联,不利于分散相的分散,从而降低了增韧效率;橡胶粒子的空洞化促使基体发生剪切屈服是其主要的形变机理,LLDPE的引入能促进PBT发生进一步形变,从而提高增韧效率。

    Abstract:

    Glycidyl methacrylate (GMA) was grafted onto poly (ethylene-octene) (POE) and linear low density polyethylene (LLDPE) simultaneously through twin screw extruder, then react blended with poly (butylene terephthalate) (PBT). The finest dispersion phase composition of PBT/(POE/LLDPE)-g-GMA blends was obtained by changing the mass ratio of POE/LLDPE, and then the effect of the GMA content on rheological behavior during reactive blending, phase morphology and mechanical property of blends was researched, toughen mechanism of blend was discussed. Results show that the highest toughen efficiency is obtained when the mass ratio of POE/LLDPE is 50/50, the impact strength of blend increases with increasing of the GMA content until the GMA content beyond 5%; the melt viscosity of blends increases with increase of the GMA content, while too much GMA leads to severe cross-linking, restricts distribution of the minor phase, decreases the toughen efficiency. The tough mechanism is that the cavitation of rubber particles promotes shear yield of the matrix, the adding of LLDPE promotes PBT to further deformation, and improves toughen efficiency.

    参考文献
    相似文献
    引证文献
引用本文

王 翔,宋立新,曲 淼,任 亮,张明耀,张会轩. PBT/(POE/LLDPE)-g-GMA 共混物的力学性能与形态结构[J].高分子材料科学与工程,2014,30(11):49-53. Xiang Wang, Lixin Song, Miao Qu, Liang Ren, Mingyao Zhang, Huixuan Zhang. Mechanical Properties and Morphology of PBT / (POE/LLDPE)-Graft-GMA Blends[J]. Polymer Materials Science & Engineering,2014,30(11):49-53.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2014-11-18
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司