反应挤出马来酸酐接枝聚甲基乙撑碳酸酯的结构与热性能
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

广州市珠江科技新星(2013J2200013);中央高校基本业务费重点项目(2013ZZ0011)


Structure and Thermal Property of Maleic Anhydride Grafted Poly(Propylene Carbonate) Prepared by Reactive Extrusion
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    通过反应挤出制备马来酸酐接枝聚甲基乙撑碳酸酯(PPC-g-MA),采用红外光谱分析、滴定法、溶液黏度测试等方法表征了PPC-g-MA的结构,通过热重分析和稳态粘弹流变性能测试,研究了接枝物的热性能,分析了PPC-g-MA 结构与热性能的关系。PPC-g-MA 的红外谱图显示在1640cm-1处出现碳碳双键伸缩振动吸收峰,说明MA 成功接枝到PPC主链上。MA添加量由0.5phr增加至5phr,PPC-g-MA的接枝率、特性黏度和热稳定性先提高后降低。当MA添加量为0.5phr时,PPC-g-MA的接枝率为0.224%,此时产物的初始分解温度(T-5% )比纯PPC升高了8.2℃,特性黏度提高了1.22,复数黏度降低10%所消耗的时间延长了1875s;当MA 添加量增加到1phr时,PPC-g-MA 的接枝率和T-5% 同时达到最大值,分别为0.284%和264.8℃。研究表明当MA添加量低于1phr时,产物的接枝率和特性黏度高,可提高PPC热性能。

    Abstract:

    Poly(propylene carbonate) (PPC) is one of carbon dioxide sourced environmental friendly thermoplastic aliphatic polycarbonate. In order to improve its thermal property, maleic anhydride grafted poly (propylene carbonate) with different grafting degree was prepared by reactive extrusion. Structure of PPC-g-MA was characterized by FT-IR, titration test and intrinsic viscosity test. The thermal property was measured by TG and steady viscoelastic test. Results from FT-IR spectrum show that there exists an absorption of C=C at 1640cm-1, proving that MA was successfully grafted onto PPC. Titration test shows that the grafting rate is affected by the MA content. When the content of MA is increased from 0.5% to 1%, the grafting rate of PPC-MA (label as PPC-g-MA0.5 PPC-g-MA1, and so on) is increased from 0.224% to 0.284%, while a decrease is observed as the content of MA increases to 5%. Compared with those of pure PPC, the thermal decomposition temperature (T-5%) and steady time of steady viscoelastic measurement for PPC-g-MA0.5 is 264.3 ℃ and 3313 s, increased by 8.2 ℃and 1875 s, respectively. It is illuminated that the thermal properties of PPC could be improved effectively when MA is applied to graft PPC by reactive extrusion as the content of MA is below 1 phr.

    参考文献
    相似文献
    引证文献
引用本文

蒋 果,冯 健,黄汉雄,张水洞.反应挤出马来酸酐接枝聚甲基乙撑碳酸酯的结构与热性能[J].高分子材料科学与工程,2014,30(11):59-62. Guo Jiang, Jian Feng, Hanxiong Huang, Shuidong Zhang. Structure and Thermal Property of Maleic Anhydride Grafted Poly(Propylene Carbonate) Prepared by Reactive Extrusion[J]. Polymer Materials Science & Engineering,2014,30(11):59-62.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2014-11-18
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司