一种吸硼的触角状亲水性羟胺树脂的合成与表征
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

“973”项目(2013CB733504);“863”项目(2012AA021203)


Synthesis and Characterization of Tentacular Hydrophilic Boron Adsorption Hydroxylamine Resin
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    以氯乙酰化聚苯乙烯微球(PS-acyl-Cl)为大分子引发剂通过原子转移自由基聚合法(ATRP)引发亲水性单体丙烯酰胺(AM)和甲基丙烯酸缩水甘油酯(GMA)单体的共聚合,制得一种具有“柔性”的触角状亲水性环氧载体(PS-acyl-g-P(AM-co-GMA)),再经二乙醇胺(DEA)的环氧基开环胺化反应,得到一种含有多齿-五元螯合环的触角状亲水性羟胺树脂(PS-acyl-g-P(AM-co-GMA)-DEA)。经过合成条件优化,结果表明,用乙醇和水组成的混合溶剂,溶剂量为V(Solv)/V(DEA)=3(体积比,下同),试剂用量为n(DEA)/n(epoxy)=2(摩尔比,下同),90 ℃反应约0.25 h,羟胺树脂增重率可以达到最大值58.6%,经元素分析可得其二乙醇胺担载量最高可以达到3.51 mmol/g,环氧基的转化率最大可以高达86.5%。且羟胺树脂的增重率随着环氧载体链长的增加而增加,而环氧基的转化率也随链长的增加而增加,后者表明,链长似乎有促进作用或邻近基团促进作用。将该螯合树脂直接用于硼的吸附,其饱和吸附量约为37.7 mg/g且树脂5 min即可达到吸附平衡,与其它已报道的吸硼树脂相比,该树脂具有更高的吸附量和吸硼速率。

    Abstract:

    The hydrophilic acrylamide (AM) and glycidyl methacrylate (GMA) were initiated with PS-acyl-Cl by atom transfer radical polymerization (ATRP) to prepare tentacular hydrophilic epoxy microspheres (PS-acyl-g-P(AM-co-GMA)). Diethanolamine (DEA) was reacted with the epoxy of the carrier by ring-opening reaction, and the comb-like -NCH2CH2OH chelating polydentate ligand and five-ring hydroxylamine chelating resin (PS-acyl-g-P(AM-co-GMA-DEA)) were prepared successfully. After optimized the synthetic conditions, the results show that the polarity of the solvent has little effect on the reaction. The mixed solvent composed of ethanol and water is a better solvent; V(solv)/ V(DEA)=3 and n(DEA)/n(epoxy)= 2 are the best ratio of the reaction. When the temperature is heated at 90 ℃, the mass gain rate (ΔW1) reaches the maximum 58.6% after 0.25 h. The DEA loading is 3.51 mmol/g by elemental analysis, and the epoxy conversion rate(D-epoxy) reaches 86.5%. In addition, the ΔW1 and D-epoxy increase with increase of the chain length of the epoxy resin, and the latter shows that the length of chain or the neighboring groups play a role of promoting. The maximum boron adsorption capacity of the resin is about 37.7 mg/g and the adsorption equilibrium is observed within 5 min. Compared with other boron adsorption resin reported, the resin has more adsorption capacity and faster adsorption rate.

    参考文献
    相似文献
    引证文献
引用本文

张家宏, 刘晓宁, 丁凌鹏, 魏荣卿, 郑涛.一种吸硼的触角状亲水性羟胺树脂的合成与表征[J].高分子材料科学与工程,2014,30(12):6-10. Jiahong Zhang, Xiaoning Liu, Lingpeng Ding, Rongqing Wei, Tao Zheng. Synthesis and Characterization of Tentacular Hydrophilic Boron Adsorption Hydroxylamine Resin[J]. Polymer Materials Science & Engineering,2014,30(12):6-10.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2014-12-12
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司