分形结构聚吡咯膜的界面聚合与电容特性表征
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家重大科技专项资助项目(2011ZX06004-009);国家自然科学基金资助项目(21204072);陕西省教育厅科学研究计划项目(2010JK691)


Interfacial Polymerization and Capacitive Properties of Multifractal Dimensions Polypyrrole Film
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    以FeCl3为氧化剂,通过界面聚合手段,制备了具有三维分型结构的聚吡咯(PPy)薄膜材料。研究在不同聚合温度下得到PPy薄膜的差异,并通过扫描电子显微镜、傅里叶变换红外光谱以及循环伏安曲线进行结构和性能的表征。结果表明,聚合温度在0~30℃内对PPy分子结构影响不大,但对分子堆积的微结构作用明显;升高聚合温度,PPy比电容下降;聚合温度为0℃时,在1mol/LNaNO3 电解液中,扫描速率为50mV/s时,PPy电极比电容为448.2F/g,循环1000次后保持87.3%。

    Abstract:

    Multifractal dimensions polypyrrole (PPy) films were successfully prepared using ferric perchloride as oxidant via interfacial polymerization method. The differences in PPy films prepared at different polymerization temperature were investigated. The structure and capacitive properties were characterized by SEM, FT-IR and cyclic voltammetry(CV) curves. The results indicate that when the effect of polymerization temperature range from 0 ℃ to 30 ℃ on molecular structure is inconspicuous, but on microstructure is very significant. The specific capacitance of PPy is decreased with increase of the polymerization temperature, and the PPy electrode specific capacitance at 448.2 F/g is obtained when the PPy material is prepared at 0 ℃, and the electrode was measured at the scan rate of 50 mV/s in 1 mol/L NaNO3 aqueous solution. Additionally, cyclic stability tests show that specific capacitance of electrodes maintains 87.3% of the initial value up to 1000 redox cycles.

    参考文献
    相似文献
    引证文献
引用本文

黄天柱,杨庆浩,屠钟艺,李会录,杨林涛.分形结构聚吡咯膜的界面聚合与电容特性表征[J].高分子材料科学与工程,2015,31(2):41-45. Tianzhu Huang, Qinghao Yang, Zhongyi Tu, Huilu Li, Lintao Yang. Interfacial Polymerization and Capacitive Properties of Multifractal Dimensions Polypyrrole Film[J]. Polymer Materials Science & Engineering,2015,31(2):41-45.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2015-02-23
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司