自由基引发剂对聚α-甲基苯乙烯热降解性能的影响
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家高技术发展计划项目


Effect of Radical Initiator on the Thermal Degradation of Poly(Alpha-Methylstyrene)
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    降解芯轴技术是制备激光惯性约束聚变靶丸的重要技术之一。利用热分析技术研究了3种不同引发剂(偶氮二异丁腈(AIBN)、过氧化二叔丁基(DTBP)、过氧化苯甲酰(BPO))对聚α-甲基苯乙烯(PAMS)热降解温度的影响,采用热裂解-气相色谱质谱联用技术分析了PAMS降解产物。研究表明,加入DTBP后,能较大降低PAMS的热降解温度,且不改变PAMS主要降解产物,其完全降解温度为339.8℃,相对未添加引发剂的PAMS,降低近50℃;此外,DTBP加入只起催化降解作用,其添加量的大小对PAMS热降解影响不大,但为降低制靶工艺不确定性,添加DTBP的含量应越小越好。而加入AIBN和BPO 的PAMS完全降解温度分别为364.5℃和374.3 ℃,对提高PAMS的热降解性能没有较大改善,且加入AIBN后会有大分子降解产物出现,直接影响芯轴微球的降解性能及目标靶丸的球形质量。

    Abstract:

    The decomposable mandrel technique is an important method for fabrication inertial confinement fusion targets. The effects of three kinds of initiators including azobidsisobutyronitrile(AIBN),benzoyl peroxide(BPO) and di-tert-butyl peroxide(DTBP) on the thermal degradation of poly(α-methylstyrene)(PAMS) were investigated by TG/DTG. The thermal pyrolysis products of PAMS were characterized by GC-MS. The experimental results show that the complete degradation temperature of PAMS is 339.8 ℃ with adding DTBP, and 50 ℃ less than that of PAMS without initiators. The thermal pyrolysis behaviour of PAMS is not affected by the DTBP content. To reduce uncertainty of target fabrication, the DTBP content is as little as possible. However, the complete degradation temperatures of PAMS with adding AIBN or BPO are 364.5 ℃ and 374.3 ℃, respectively, and there are macromolecules in the pyrolysis products of PAMS with AIBN, which could reduce degradation of PAMS and the quality of targets.

    参考文献
    相似文献
    引证文献
引用本文

马 霜,黄亚文,李 芳,陈素芬,张占文,杨军校.自由基引发剂对聚α-甲基苯乙烯热降解性能的影响[J].高分子材料科学与工程,2015,31(2):61-66. Shuang Ma, Yawen Huang, Fang Li, Sufen Chen, Zhanwen Zhang, Junxiao Yang. Effect of Radical Initiator on the Thermal Degradation of Poly(Alpha-Methylstyrene)[J]. Polymer Materials Science & Engineering,2015,31(2):61-66.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2015-02-23
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司