氧化亚铜对封端聚氨酯/环氧树脂涂料力学和防污性能的影响
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Influence of Cuprous Oxide on Mechanical and Antifouling Property of Blocked Polyurethane/Epoxy Blend Coatings
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    研究了氧化亚铜对新型封端聚氨酯(BPU)/环氧树脂(EP)共混物涂料的拉伸强度、剪切强度和表面防污性能的影响。拉伸、剪切实验结果表明,涂层的拉伸强度和剪切强度随着氧化亚铜的增加均有所下降;加入纳米氧化亚铜对涂层的影响更加明显,涂层的拉伸强度和剪切强度均大幅下降;铜离子渗出率测定结果表明,随着氧化亚铜用量的增加,铜离子渗出率增大,用纳米氧化亚铜替代氧化亚铜效果并不明显,稳定时的铜离子渗出速率变化不大,用聚乙二醇(PEG)硅烷处理的铜离子渗出率高于未经处理的氧化亚铜的渗出率;透射电镜分析表明,经硅烷处理后的氧化亚铜在树脂中分散性较好,而纳米氧化亚铜和氧化亚铜均出现一定程度的团聚现象;实海挂板试验结果表明,涂料中添加氧化亚铜、纳米氧化亚铜和经PEG硅烷改性后的氧化亚铜的涂层防污性能依次增强,当80phr氧化亚铜的防污效果较好。

    Abstract:

    The influence of cuprous oxide (Cu2O) on tensile strength, shear strength and surface properties of blocked polyurethane/epoxy (BPU/EP) resin blend coatings was investigated. The results of tensile, shear experiments show that the tensile and shear strength of the coatings decrease as the Cu22O amount increases; the effect of adding nano-cuprous oxide(nano- Cu2O) in coatings is even obvious. The results of the copper-ion release rate show that the copper-ion release rate increases as the Cu2O amount increases and the replacement affection of nano- Cu2O is not obvious, and the copper-ion release rate of the Cu2O modified with polyethylene glycol(PEG) silane is higher than that of the untreated one. TEM images show that in the resin, nano- Cu2O and Cu2O appear a certain degree of reunion phenomenon but dispersion of cuprous oxide modified with PEG silane in the resin is better. The panel test results show that the effect of Cu2O, nano- Cu2O and the Cu2O modified with PEG silane on the antifouling performance of coatings gradually is improved and the antifouling property of 80 phr cuprous oxide is best.

    参考文献
    相似文献
    引证文献
引用本文

刘明光, 晏欣, 李亮, 王源升.氧化亚铜对封端聚氨酯/环氧树脂涂料力学和防污性能的影响[J].高分子材料科学与工程,2015,31(4):57-60. Mingguang Liu, Xin Yan, Liang Li, Yuansheng Wang. Influence of Cuprous Oxide on Mechanical and Antifouling Property of Blocked Polyurethane/Epoxy Blend Coatings[J]. Polymer Materials Science & Engineering,2015,31(4):57-60.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2015-04-21
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司