混合型聚氨酯/有机蒙脱土纳米复合材料的制备与表征
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

湖北省自然科学基金面上项目(2014CFB832)


Preparation and Characterization of Hybrid Polyurethane/Organic Montmorillonite Nanocomposites
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    利用原位插层法制备出了混合型聚氨酯插层有机蒙脱土纳米复合材料(HPU/OMMT);研究了聚己二酸-1,4-丁二醇酯二醇插层有机蒙脱土(PBA/OMMT)用量对纳米复合材料平均粒径、黏度、Zeta电位、玻璃化转变温度(Tg)、力学性能和热稳定性等性能的影响。结果表明,增加PBA/OMMT的用量,乳液的平均粒径逐渐增大,黏度变化不大, Zeta电位依次降低;同时,纳米复合材料的Tg从-58.87 ℃上升至-57.51 ℃,拉伸强度和断裂伸长率均先上升后降低。当OMMT的质量分数为5%时,HPU/OMMT膜的初始降解温度和中心降解温度分别为319.6 ℃和416.2 ℃,表现出较好的热稳定性。

    Abstract:

    Hybrid polyurethane/organic montmorillonite nanocomposites (HPU/OMMT) were synthesized via intercalating polymerization process. The influence of the poly-1,4-butylene adipate glycol/organic montmorillonite (PBA/OMMT) content on average particle size, zeta potential, viscosity, glass transition temperature (Tg), mechanical properties and thermal stability of the nanocomposites were studied. The results show that with increasing of the PBA/OMMT content, the average particle size of emulsion increases gradually, the viscosity changes a little and the zeta potential decreases. Meanwhile, the Tg of nanocomposites is increased from -58.87 ℃ to -57.51 ℃, both the tensile strength and elongation are increased first and then decreased. When the mass fraction of OMMT is 5%, the initial degradation temperature and center degradation temperature of the HPU/OMMT films are 319.6 ℃ and 416.2 ℃ respectively, which exhibit good thermal stability.

    参考文献
    相似文献
    引证文献
引用本文

何栋, 秦齐, 周宏伟, 李建华, 郑化, 易英.混合型聚氨酯/有机蒙脱土纳米复合材料的制备与表征[J].高分子材料科学与工程,2015,31(5):139-143. Dong He, Qi Qin, Hongwei Zhou, Jianhua Li, Hua Zheng, Ying Yi. Preparation and Characterization of Hybrid Polyurethane/Organic Montmorillonite Nanocomposites[J]. Polymer Materials Science & Engineering,2015,31(5):139-143.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2015-05-24
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司