增容剂对微晶纤维素增强淀粉塑料的影响
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Effect of Compatibilizer on Microcrystalline Cellulose Reinforced Starch-Based Plastics
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    首先用微晶纤维素(MCC)对热塑性淀粉(TPS)进行增强,再将低密度聚乙烯(LDPE)与增强后的TPS共混,并以马来酸酐接枝聚乙烯(MA-g-PE)作为增容剂,制成MCC/ TPS/ LDPE复合材料。通过电子拉力机、冲击强度试验机、热重法、转矩流变仪和接触角测定仪,研究了不同用量的MA-g-PE对MCC/ TPS/ LDPE性能的影响。结果表明,增容剂的加入,使复合材料的拉伸强度先增大后减小,断裂伸长率和冲击强度不断增大,材料韧性显著提高;对复合材料的热稳定性有所改善,但影响较小;当添加量小于6%时,加工性能提高明显;此外,耐水性提高显著。总体而言,当MA-g-PE的添加量为4%时,材料的综合性能最好(拉伸强度为13.52 MPa,冲击强度为6.38 kJ/m2,接触角为94.47°)。

    Abstract:

    In this paper, the microcrystalline cellulose (MCC) was used to enhance starch-based plastics, then low density polyethylene (LDPE) was blend with enhanced thermoplastic starch (TPS), and using maleic anhydride grafted polyethylene (MA-g-PE) as compatibilizer, MCC/ TPS/ LDPE composite materials were made. Through electronic tensile testing machine, impact strength testing machine, thermogravimetric method, rheometer and contact angle measurement, the effect of the different content of MA-g-PE on performance of MCC/ TPS/ LDPE was studied. The results show that, the tensile strength of composites increases first and then decreases after adding the compatibilizer, and the elongation at break and impact strength of the composite increase, so the toughness of materials is significantly improved; the thermal stability of composites is also improved; the compatibilizer is beneficial to improve the processing performance of composites, only when the content is less than 6%; the water resistance is enhanced obviously. Overall, when the addition of MA-g-PE is 4%, the performance of the composites is the best (tensile strength is 13.52 MPa, impact strength is 6.38 kJ/m2 and the contact angle of 94.47 °).

    参考文献
    相似文献
    引证文献
引用本文

郭斌, 王礼建, 董亚强, 李本刚, 范磊, 李盘欣.增容剂对微晶纤维素增强淀粉塑料的影响[J].高分子材料科学与工程,2015,31(6):112-115. Bin Guo, Lijian Wang, Yaqiang Dong, Bengang Li, Lei Fan, Panxin Li. Effect of Compatibilizer on Microcrystalline Cellulose Reinforced Starch-Based Plastics[J]. Polymer Materials Science & Engineering,2015,31(6):112-115.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2015-06-19
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司