蒙脱土和碳纳米管共掺改性环氧树脂复合材料的力学性能
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

黑龙江省电介质工程国家重点实验室资助项目(DE2012B02)


Effect of Montmorillonite and Carbon Nanotubes on the Mechanical and Thermal Properties of Epoxy Composites
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用有机化蒙脱土(OMMT)和碳纳米管(MWCNTs)2种纳米材料改性双酚A型环氧树脂。通过溶液共混法制备OMMT/EP、MWCNTs/EP、OMMT/MWCNTs/EP环氧树脂纳米复合材料。利用扫描电子显微镜观察了复合材料的冲击断面,测试了复合材料的力学性能和热性能,探讨了OMMT、MWCNTs增韧环氧树脂的机理。结果表明,当试样中OMMT质量分数为4%,MWCNTs质量分数为0.7%时,OMMT/EP、MWCNTs/EP和OMMT/MWCNTs/EP的冲击强度分别达到16.8 kJ/m2,23.1 kJ/m2,30.4 kJ/m2,较未掺杂环氧树脂分别提高了16.7%,60.4%,110%。弯曲强度较未改性环氧树脂分别提高了27.54%,35.74%,54.12%。3种复合材料的热分解温度和马丁耐热温度均较未改性环氧树脂略有提高。

    Abstract:

    Bisphenol A type epoxy resin was modified with two kinds of nanometer materials (organic montmorillonite (OMMT) and carbon nanotubes (MWCNTs)). Three kinds of epoxy resin nanocomposites (OMMT/EP, MWCNTs/EP, OMMT/MWCNTs/EP) were prepared by solution blending method. The impact section of composite materials was observed by scanning electron microscope, mechanical properties and thermal properties of the composites were tested, and the mechanism of carbon nanotubes and montmorillonite toughening epoxy matrix was analyzed. The results show that incorporating 4% OMMT and 0.7% modified MWCNTs into epoxy matrix, the impact strength of OMMT/EP,MWCNTs/EP and OMMT/MWCNTs/EP increases to 16.8 kJ/m2, 23.1 kJ/m2, 30.4 kJ/m2 respectively; the bending strength is increased by 27.54%, 35.74%, 54.12% respectively than the unmodified epoxy resin. The thermal decomposition temperature and Martin heat resistance temperature of the three kinds of composites are slightly higher than those of unmodified epoxy resin.

    参考文献
    相似文献
    引证文献
引用本文

张明艳, 李明川, 周诚智, 陈金玉, 吴子剑.蒙脱土和碳纳米管共掺改性环氧树脂复合材料的力学性能[J].高分子材料科学与工程,2015,31(6):116-121. Mingyan Zhang, Mingchuan Li, Chengzhi Zhou, Jinyu Chen, Zijian Wu. Effect of Montmorillonite and Carbon Nanotubes on the Mechanical and Thermal Properties of Epoxy Composites[J]. Polymer Materials Science & Engineering,2015,31(6):116-121.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2015-06-19
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司