环氧树脂增强改性开孔酚醛泡沫的制备及表征
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

横向项目(0030905501620)


Preparation and Characterization of High Strength Open Cell Phenolic Foam Modified with Epoxy Resin
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    利用开环的环氧基团与羟基、亚甲基羟基发生醚化反应改性甲阶酚醛树脂,以阴离子和非离子表面活性剂复配型乳化剂和混酸固化剂,采用物理发泡法制备了高强度开孔酚醛泡沫(PF)。考察了改性树脂的结构、固化过程和开孔泡沫的力学性能、热性能、吸水性能以及孔结构。结果表明,阴离子乳化剂十二烷基磺酸钠(SDS)能促进开孔结构的形成,随着环氧树脂含量增加,环氧改性开孔PF泡沫的孔分布变得越均匀,孔径越小。泡沫的热导率、开孔率以及吸水量与SDS含量及环氧树脂加入量有关,改性酚醛泡沫的开孔率最高能达到90.96%。而且当环氧树脂质量分数为5%时就能提高泡沫的热稳定性,当环氧树脂质量分数达到10%, SDS质量分数为65%时,泡沫的开孔率、吸水率及热导率均达到最大值。差示扫描量热法固化分析表明环氧改性的酚醛树脂有更低的固化反应热。环氧树脂改性的开孔PF泡沫具有良好的分离过滤效果,而且环氧改性的开孔泡沫中相互连通的微孔结构也显著增强了泡沫的力学性能。

    Abstract:

    High strength open cell phenolic foam (PF) modified with different epoxy resins was prepared by physical foaming method with mixed acid curing agent and compound emulsifiers containing anionic and non-ionic surfactant. The ring-opening epoxy groups react with hydroxyl and methylol group via etherification for chemical modification of resol. The viscosity of resin was studied. The cellular, water absorption, apparent density and mechanical and thermal properties of fabricated foams were characterized. The results show the phenol modified with epoxy was successfully investigated by FT-IR. The open-celled pore structure revealed by SEM demonstrates that more homogeneous and smaller open cells exist with increasing dosage of epoxy. When the content of epoxy increases from 0% to 10%, the thermal conductivity, water absorption and porosity of PF gradually increase. The highest open cell porosity rises up to 90.96%. And the DSC data demonstrates that modified resols exhibit lower endothermic and curing exothermic heat, and the viscosity of resol could be effectively controlled with appropriate amount of epoxy. Anionic surfactant, sodium dodecyl sulfonate (SDS) which is better compatible with resol than other anionic surfactants, could promote formation of open cells and produce good homogeneous and moderate micro-pores. The porous structure controlled by the content of epoxy resin and the ratio of SDS/tween-80 greatly improves the mechanical strengths of PF.Also modified open cell PF possesses excellent filtration and separation. In addition, open cell PF modified with 5% content of epoxy significantly improves the thermal stability.

    参考文献
    相似文献
    引证文献
引用本文

徐前, 李瑞海, 巩锐, 刘川, 崔梦雅, 辜兴悦.环氧树脂增强改性开孔酚醛泡沫的制备及表征[J].高分子材料科学与工程,2015,31(6):126-132. Qian Xu, Ruihai Li, Rui Gong, Chuan Liu, Mengya Cui, Xingyue Gu. Preparation and Characterization of High Strength Open Cell Phenolic Foam Modified with Epoxy Resin[J]. Polymer Materials Science & Engineering,2015,31(6):126-132.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2015-06-19
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司