硝酸铝溶解制备增塑壳聚糖薄膜的结构与性能
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金资助项目(51273129)


Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用硝酸铝[Al(NO3)3·9H2O]水溶液为溶剂溶解壳聚糖,并加入甘油增塑改性制备壳聚糖薄膜,研究了Al(NO3)3·9H2O对壳聚糖的溶解效果和Al(NO3)3·9H2O/甘油协同增塑改性壳聚糖的效果。采用紫外可见光透光率,X射线衍射和力学性能测试研究了所得壳聚糖薄膜的光学性能,结晶性能和力学性能。研究结果表明,Al(NO3)3·9H2O水溶液可较好地溶解壳聚糖,但当Al(NO3)3·9H2O加量过高时,Al(NO3)3·9H2O水解生成的Al(OH)3会破坏壳聚糖的成膜性能。Al(NO3)3·9H2O适宜的质量分数为75%。当加入质量分数为75%的Al(NO3)3·9H2O改性时,壳聚糖薄膜的结晶度提高,透光率增加。力学性能测试结果表明,加入甘油改性后壳聚糖薄膜的拉伸强度降低,断裂伸长率提高。

    Abstract:

    The Al(NO3)3·9H2O aqueous solution was used to dissolve chitosan and the chitosan films were prepared by solution casting. Glycerol was added to plasticize chitosan film. The optical, crystalline and mechanical properties of chitosan films were tested by X-ray diffraction, UV-Vis spectrum and tensile testing respectively. The results show that chitosan could be dissolved in the Al(NO3)3·9H2O aqueous solution, but the higher amount of Al(NO3)3·9H2O would lead to loss of film forming ability of chitosan. The appropriate amount of Al(NO3)3·9H2O for chitosan is 75%(mass fraction). The addition of glycerol could increase the transmittance of Al(NO3)3·9H2O doped chitosan film. However, the transmittance of Al(NO3)3·9H2O doped chitosan film would decrease with the increasing amount of glycerol. The XRD results show that the addition of glycerol would increase the crystallinity of Al(NO3)3·9H2O doped chitosan film. The tensile testing results show that the glycerol would increase the elongation at break of chitosan film and decrease the tensile strength.

    参考文献
    相似文献
    引证文献
引用本文

江献财, 翁森, 施莉巧, 李晓, 张卫英, 张熙.硝酸铝溶解制备增塑壳聚糖薄膜的结构与性能[J].高分子材料科学与工程,2015,31(7):64-68. Xiancai Jiang, Sen Weng, Liqiao Shi, Xiao Li, Weiying Zhang, Xi Zhang.[J]. Polymer Materials Science & Engineering,2015,31(7):64-68.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2015-07-24
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司