纺丝速度对聚苯硫醚纤维结构与性能的影响
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

山西省回国留学人员科研资助项目(2010-044);山西省自然科学(青年)基金项目(2012020021-6);太原理工大学青年基金项目(2012L027)


Effect of Spinning Speed on Structure and Properties of Poly-Phenylene Sulfide Fiber
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    通过熔融纺丝方法制备了不同纺丝速度的聚苯硫醚(PPS)纤维,并采用差示扫描量热仪、声速仪、电子单纱强力仪等对比研究了不同纺速制备的初生纤维和成品丝可纺性、结晶行为、取向程度、力学性能以及尺寸稳定性的差异。结果表明,在熔融纺丝过程中,不同的纺速对聚苯硫醚纤维结构与性能有很大影响。随着纺速的增加,通过调整徐冷温度和牵伸倍数保证了良好的可纺性,并且PPS纤维的取向度、结晶度和断裂强度均呈现先增加后降低的趋势,而尺寸稳定性随纺速的提高出现先下降后升高的趋势;PPS初生纤维的各项性能与成品丝的变化趋势一致。纤维的结构与性能在纺速为880 m/min左右时达到最佳,断裂强度达到3.33 cN/dtex。

    Abstract:

    Ploy-phenylene sulfide (PPS) fibers were prepared by melt treatment process at different spinning speeds.The spinnability crystallization behavior, degree of orientation,mechanical properties, dimensional stability of PPS as-spun fiber and draw-twist were studied by differential scanning calorimetry (DSC), sound velocity meter, electronic yarn strength tester, etc. The results show that the different spinning speed has a great influence on the structure and properties of PPS fibers during melt spinning process. With the spinning speed increasing, adjusting slow cooling temperature and drawing ratio ensure better spinnability, and orientation, crystallinity and breaking strength of PPS fibers increases to a maximum firstly and then decrease. Whereas, the dimensional stability of PPS fibers decreases to a minimum firstly and then increase. The change trend of various properties of PPS as-spun fiber is consistent compared with the PPS draw-twist. When the spinning speed is controlled about 880m/min, the structure and properties of PPS fibers are optimal, and its breaking strength is up to 3.33 cN/dtex.

    参考文献
    相似文献
    引证文献
引用本文

张勇, 相鹏伟, 张蕊萍, 戴晋明, 连丹丹.纺丝速度对聚苯硫醚纤维结构与性能的影响[J].高分子材料科学与工程,2015,31(7):114-118. Yong Zhang, Pengwei Xiang, Ruiping Zhang, Jinming Dai, Dandan Lian. Effect of Spinning Speed on Structure and Properties of Poly-Phenylene Sulfide Fiber[J]. Polymer Materials Science & Engineering,2015,31(7):114-118.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2015-07-24
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司