溶液聚偏氟乙烯静电纺纤维基超高分子量聚乙烯锂电池隔
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Preparation of Electrospun Polyvinylidene Fluoride Fibers Based UHMWPE Lithium Battery Separator
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    通过研究溶液浓度及电压等因素对聚偏氟乙烯(PVDF)溶液静电纺丝的影响,确定最佳纺丝条件制备出聚偏氟乙烯纳米纤维。并与超高分子量聚乙烯(UHMWPE)隔膜复合,成功制备出PVDF纳米纤维基超高分子量聚乙烯锂电池隔膜。对该锂电池隔膜的性能测试结果表明,该隔膜的孔隙率为55%,隔膜在横纵向的热收缩率均在1%以内,放电容量比同等测试条件下的超高分子量聚乙烯隔膜提高了4.8%,并且循环稳定性良好,可作为锂电池隔膜使用。

    Abstract:

    Polyvinylidene fluoride (PVDF) nanofiber was successfully prepared after determining the optimal electrospun parameters. Then the PVDF nanofiber based ultra-high molecular weight polyethylene(UHMWPE) lithium battery separator was prepared by compounding UHMWPE membrane with the prepared PVDF nanofiber. Last, the lithium battery separator performance was tested. The results show that the membrane porosity is 55%, the diaphragm in the transverse heat shrinkage along the longitudinal direction is less than 1%, the discharge capacity ratio of ultrahigh molecular weight polyethylene composite membrane is increased by 4.8%, and the lithium battery separator has good cycle stability.

    参考文献
    相似文献
    引证文献
引用本文

刘太奇, 马福瑞, 赵云腾.溶液聚偏氟乙烯静电纺纤维基超高分子量聚乙烯锂电池隔[J].高分子材料科学与工程,2015,31(10):128-132. Taiqi Liu, Furui Ma, Yunteng Zhao. Preparation of Electrospun Polyvinylidene Fluoride Fibers Based UHMWPE Lithium Battery Separator[J]. Polymer Materials Science & Engineering,2015,31(10):128-132.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2015-10-20
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司