Abstract:There is an apparent layering behavior of poly(ethylene terephthalate) (PET) fiber film by melt-electrospinning. The depositing location of the end of PET melt jet in melt-electrospinning was observed by high-speed photography device; then, the circular layered fiber sheets’ radius, mass and fibers’ distribution were measured; in addition, the fibers morphologies of layered fiber sheets were investigated by SEM. The results show that because of the accumulated electric charges in fiber film, PET jet deposits with reciprocating movement intermittently between center and side of fiber film, causing formation of binding layer fibers who have separating function and then producing the layering structure in fiber film. The PET fiber film electrospun in 90 min, from center to side, could be divided freely into 13 concentric fiber sheets, and the sheets’ radius increases linearly while their mass increases unstably and piecewise, moreover, the outer layered films show the appearance of the thin center while the thick edge. The average fiber diameters of each layered film are about 2 μm and distribute evenly, besides, the fiber diameter of the layered films from center to side increases slightly due to the reduced electric potential difference; the self-bonded fibers in inner layered films are owing to the smaller and thicker film with short time for cooling the PET jet.