熔体静电纺的电场分布对三维自组装聚对苯二甲酸乙二酯纤维膜形貌的影响
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家高技术研究发展计划(863)(2012AA030313);江苏省产学研联合创新资金前瞻性研究( BY2014023-06)


Effects of Electric Field Distribution of Melt-Electrospingning on Morphologies of 3-Dimensional Self-Assembled Polyethylene Terephthalate Fiber Films
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    熔体静电纺可自组装三维锥状纤维膜。借助ANSYS软件模拟熔体静电纺反纺工艺不同参数(纺丝电压、接收距离、接收板面积)条件下的电场分布,探讨电场分布对熔体静电纺三维自组装聚对苯二甲酸乙二酯(PET)纤维膜几何结构与纤维形貌的影响。结果表明,在单喷嘴-平板结构模型中,提高电压将整体增强空间电场强度,同时电场不均匀性也被放大,所纺三维PET纤维膜尺寸(底面积、厚度、质量)有所增加,纤维膜锥角变小,纤维直径明显下降;接收距离的改变对接收板表面的电场影响显著,随着接收距离的增加,纤维膜尺寸有所减小,当接收距离较小时,纤维膜顶端锥角仅为56°,而纤维直径变化不大;接收板面积的缩小可以改善喷嘴与接收板间及接收板表面电场分布的均匀性,纤维膜尺寸增加,纤维膜锥角逐渐变小,纤维膜表面的镂空现象明显,所纺纤维平均直径稍有减小。

    Abstract:

    3-Dimensional polyethylene terephthalate (PET) fiber films with conical appearance can self-assemble by melt-elsctrospinning. Electric field distributions under different conditions (spinning voltage, accepted distance and collector area) in reverse-melt-electrospinning process were simulated by ANSYS software; effects of electric field distribution on geometries and morphologies of 3-dimensional self-assembled PET fiber films were investigated. Results show that in the single nozzle-plate structure model, when improving voltage, the whole space electric field intensities are enhanced and their unevenness is enlarged as well, the sizes (bottom area, thickness and mass) of melt-electrospun PET fiber films get increased while the core angles of films and fiber diameters are decreased greatly. The changes of accepted distance apparently affect the electric field on the collector surface, increasing accepted distance would decrease sizes of the films; the core angle is only 56° with the small accepted distance and fiber diameters are with few change. Decreasing the collector area could modify the evenness of the electric field between nozzle and collector as well as decrease sizes of the films and core angles; the hollow on the surface of film is obvious and the fiber diameters are decreased slightly.

    参考文献
    相似文献
    引证文献
引用本文

王宏, 杜泽静, 颜奥林, 徐阳, 魏取福.熔体静电纺的电场分布对三维自组装聚对苯二甲酸乙二酯纤维膜形貌的影响[J].高分子材料科学与工程,2016,32(2):126-132. Hong Wang, Zejing Du, Aolin Yan, Yang Xu, Qufu Wei. Effects of Electric Field Distribution of Melt-Electrospingning on Morphologies of 3-Dimensional Self-Assembled Polyethylene Terephthalate Fiber Films[J]. Polymer Materials Science & Engineering,2016,32(2):126-132.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2016-01-26
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司