四甲基氢氧化铵改性聚偏氟乙烯一步接枝丙烯酰胺基甲基丙磺酸膜的研制
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金资助项目(51474133);内蒙古自治区自然科学基金资助项目(2013MS0210);内蒙古科技大学大学生科技创新基金(2014073)


Preparation and Characterization of Membranes Synthesized via One-Step Grafting Acrylamido-Methyl Propane Sulfonic onto Poly(Vinylidene Fluoride) Modified by Tetramethylammonium Hydroxide
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    利用一步合成法,将2-丙烯酰胺基-2-甲基丙磺酸(AMPS)直接接枝到四甲基氢氧化铵(TMAH)改性的聚偏氟乙烯(PVDF)基质中,制得PVDF-g-AMPS膜。采用傅里叶变换红外光谱和能谱扫描电镜检测膜的结构、形貌及硫的分布,并研究了不同质量分数的TMAH对此膜电导率和甲醇渗透率的影响。结果表明,TMAH改性PVDF脱去HF产生C=C且AMPS成功接枝到PVDF上,硫元素在膜内外分布均匀;膜的电导率和甲醇渗透率随TMAH含量的增多而增大,TMAH质量分数为20%时,室温下电导率最大为0.0857 S/cm,甲醇渗透率为3.56×10-7 cm2/s。热重分析表明,膜的热稳定性良好,耐热温度高达260 ℃。该膜作为电解质材料的直接甲醇燃料电池(DMFC)功率密度达到18.81 mW/cm2。

    Abstract:

    The new method of single-step synthesis was applied to prepare poly(vinylidene fluoride) (PVDF) directly grafted with 2-acrylamido-2-methyl-1-propanesulfonic acid (PVDF-g-AMPS) membranes. By this new method, PVDF was modified with the tetramethylammonium hydroxide (TMAH) in advance. The microstructures, morphologies, and sulfur distribution of the membrane were characterized by FT-IR, SEM, and energy-dispersive X-ray spectroscopy (EDX). The effects of the TMAH mass fraction in methanol solution on proton conductivity and methanol permeability of the membranes were investigated. Experimental results show that PVDF is dehydrofluorinated by TMAH and obtained carbon-carbon double bond. AMPS is successfully grafted onto PVDF; the distribution of sulfur is homogeneous in the interior and surface of the membrane. The proton conductivity of proton exchange membrane and the methanol permeability increase with the TMAH mass fraction in methanol solution, and when the content of TMAH is 20%, the proton conductivity of membrane is 0.0857 S/cm at ambient temperature and the methanol permeability coefficient is 3.56×10-7 cm2/s. Besides, the membranes exhibit excellent thermal stability up to approximately 260 ℃, verified by thermal gravimetric analysis (TGA). The peak power density of direct methanol fuel cell (DMFC) fabricated with above membrane is 18.81 mW/cm2.

    参考文献
    相似文献
    引证文献
引用本文

张董, 郭贵宝, 郝燕, 安胜利, 张嘉汉, 闫凯波.四甲基氢氧化铵改性聚偏氟乙烯一步接枝丙烯酰胺基甲基丙磺酸膜的研制[J].高分子材料科学与工程,2016,32(4):132-136. Dong Zhang, Guibao Guo, Yan Hao, Shengli An, Jiahan Zhang, Kaibo Yan. Preparation and Characterization of Membranes Synthesized via One-Step Grafting Acrylamido-Methyl Propane Sulfonic onto Poly(Vinylidene Fluoride) Modified by Tetramethylammonium Hydroxide[J]. Polymer Materials Science & Engineering,2016,32(4):132-136.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2016-04-19
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司