预辐照聚丙烯悬浮接枝聚苯乙烯的制备及结构性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金资助项目(51373173)


Preparation, Structure and Properties of Pre-Irradiation Polypropylene Grafted Polystyrene in Suapension
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    通过预辐照和悬浮接枝技术制备聚丙烯接枝聚苯乙烯(PP-g-PS)。利用红外光谱、核磁共振、X射线衍射、差示扫描量热分析、旋转流变仪及高压击穿实验对PP-g-PS的结构和性能进行了表征。结果表明,PP-g-PS的FT-IR在1493 cm-1,1601 cm-1和3027 cm-1处出现了新的吸收峰,其中1601 cm-1和3027 cm-1分别为PS苯环上C=C和C-H的特征吸收峰;1H-NMR在1.2,1.4和2.0位置处出现新的化学位移峰,在δ7.1和7.2处出现2组峰,这是PS苯环上氢的化学位移,证明PS已接枝到PP的大分子链上。与PP相比,PP-g-PS的熔融温度和结晶度降低,结晶温度升高;随接枝率增大,PP-g-PS的结晶温度升高; PP-g-PS的耐电压击穿性能好,其击穿场强可达PP的1.4倍。

    Abstract:

    Polypropylene grafted polystyrene (PPg-PS) was prepared by pre-irradiation suspension grafting. The structure and properties of PP-g-PS were investigared by FT-IR, 1H-NMR, WAXD, DSC, GPC, rotational rheometer and breakdown voltage test. The FT-IR spectra of PP-g-PS show some new peaks at 3027 cm-1,1601 cm-1 and 1493 cm-1, which are attributed to C-H bond and C=C double bond of benzene ring. The 1H-NMR spectra of PP-g-PS show new chemical shift peaks at 2.0, 1.4, 1.2, 7.2 and 7.1, which are attributed to the H from benzene ring in PS. These results indicate that PS is successfully grafted onto PP molecular chains. The melting temperature and molten enthalpy of PP-g-PS are lower than those of PP. With increasing of the degree of grafting of PP-g-PS, the crystallization temperature increases and crystallization enthalpy gradually decreases. Electrical property results reveal that the breakdown voltage value of PP-g-PS is 1.4 times higher than that of pure PP.

    参考文献
    相似文献
    引证文献
引用本文

李文斐, 姚占海, 孟玥, 董群, 李莉霞, 郝秀华.预辐照聚丙烯悬浮接枝聚苯乙烯的制备及结构性能[J].高分子材料科学与工程,2016,32(6):22-25. Wenfei Li, Zhanhai Yao, Yue Meng, Qun Dong, Lixia Li, Xiuhua Hao. Preparation, Structure and Properties of Pre-Irradiation Polypropylene Grafted Polystyrene in Suapension[J]. Polymer Materials Science & Engineering,2016,32(6):22-25.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2016-06-11
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司