不同发泡层数低密度聚乙烯双层材料的制备及性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Preparation and Properties of Different Foamed Layers of Low Density Polyethylene Materials with Double Layers
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用四因素三水平L9(34)正交设计方法,研究4种助剂对3种发泡层数的低密度聚乙烯(LDPE)双层复合材料的密度和剥离强度的影响。结果表明:不同发泡层数时,乙烯-醋酸乙烯酯 (EVA)和乙烯-丙烯酸共聚物(EAA)组合、硬脂酸锌(ZnSt)、抗氧剂1010以及过氧化二异丙苯(DCP)用量对LDPE双层复合材料性能的影响不同。双层发泡时,ZnSt用量对密度和剥离强度的影响最大;单层发泡时,密度和剥离强度主要受ZnSt和抗氧剂用量影响;双层未发泡时,密度受这4种因素的影响较小,剥离强度主要受抗氧剂和DCP用量的影响。扫描电子显微镜观察3种发泡层数双层LDPE材料的微观结构存在明显不同。建立结构模型分析了3种发泡组合材料的性能与气体体积分数有关。

    Abstract:

    The effects of the following four factors on density and peel strength of three kinds of foamed layers of LDPE materials with double layers were investigated by orthogonal experimental design of four factors and three levels using L9(34)table. The results show that, the influences of ethylene vinyl acetate copolymer(EVA) + ethylene acrylic acid copolymer(EAA), zinc stearate (ZnSt), antioxidant1010 and dicamyl peroxide(DCP) dosage vary from different foaming layers of LDPE composite materials with double layers.When it is double-foamed, the usage of ZnSt makes the greatest influence on density and peel strength. Single foamed, density and peel strength are mainly effected by the contents of ZnSt and antioxidant. Unfoamed, density is less relevant with the four factors mentioned above, and its peel strength is primarily decided by the dosages of antioxidant and DCP.SEM patterns reflect that the microstructures of three kinds of foamed layers of LDPE materials with double layers are distinctly different. The schematic diagram shows that the properties of the three kinds of foamedmaterials are related to gas volume fraction.

    参考文献
    相似文献
    引证文献
引用本文

高玮, 郝同辉, 张作才, 杨妮, 蒋涛, 张群朝.不同发泡层数低密度聚乙烯双层材料的制备及性能[J].高分子材料科学与工程,2016,32(6):68-73. Wei Gao, Tonghui Hao, Zuocai Zhang, Ni Yang, Tao Jiang, Qunchao Zhang. Preparation and Properties of Different Foamed Layers of Low Density Polyethylene Materials with Double Layers[J]. Polymer Materials Science & Engineering,2016,32(6):68-73.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2016-06-11
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司