P34HB的4HB含量对PLLA/P34HB共混物结构和性能的影响
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金资助项目(51422305)


Effect of 4HB Content of P34HB on the Structure and Properties of PLLA/P34HB Blends
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用熔融共混方法制备了聚乳酸/聚(3-羟基丁酸-4-羟基丁酸酯) (PLLA/P34HB)共混物,其中P34HB的4HB摩尔含量分别为11%与17%。通过扫描电子显微镜、动态力学分析、差示扫描量热仪和力学性能测试,考察了共混物的相容性、熔融行为与力学性能。结果表明,当P34HB组分质量分数为25%以上时,共混物两相玻璃化转变温度(Tg)相互靠近,为部分相容体系,且4HB含量越少,PLLA/P34HB共混物的相容性越好。共混物中PLLA的结晶性能随P34HB含量的增加而降低,且4HB含量越大,由于较差的相容性导致P34HB对PLLA的链段运动能力影响减小,共混物中PLLA结晶性能越好。随P34HB 含量的增加,共混物的强度降低,断裂伸长率升高,且4HB含量越大,共混物力学性能由于两相相容性较差而低于4HB含量较低的共混体系。

    Abstract:

    The blends of poly (lactic acid) (PLLA) and poly (3-hydroxybutyrate-co-4-hydroxybutyrate) (P34HB) with 4-hydroxybutyrate (4HB) molar fraction of 11% and 17% were prepared via melt blending. In order to study the effect of 4HB content of P34HB on the miscibility, melting behaviors and mechanical properties of the blends, scanning electronic microscope (SEM), dynamic mechanical analysis (DMA), differential scanning calorimetry (DSC) and mechanical test were used. The results show that the two glass-transition temperatures (Tg) of PLLA/P34HB blends get close to each other, meaning that PLLA/P34HB blend is partially miscible at the content of P34HB higher than 25%. Besides, the more 4HB content, the better miscibility of PLLA/P34HB. The crystallization ability of PLLA for PLLA/P34HB decreases with increasing P34HB content, and the crystallization ability of PLLA for PLLA/P34HB with molar fraction 17% 4HB is greater than the one with 11% 4HB due to the inferior miscibility of the former. The tensile strength of PLLA/P34HB blends reduces and the elongation at break of PLLA/P34HB blends improves with increasing content of P34HB. Meanwhile, the mechanical properties of PLLA/P34HB are lower for the blends with higher 4HB content because of the poorer miscibility.

    参考文献
    相似文献
    引证文献
引用本文

李媛媛, 钱祉祺, 包睿莹, 杨伟, 杨鸣波. P34HB的4HB含量对PLLA/P34HB共混物结构和性能的影响[J].高分子材料科学与工程,2016,32(6):96-100. Yuanyuan Li, Zhiqi Qian, Ruiying Bao, Wei Yang, Mingbo Yang. Effect of 4HB Content of P34HB on the Structure and Properties of PLLA/P34HB Blends[J]. Polymer Materials Science & Engineering,2016,32(6):96-100.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2016-06-11
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司