聚乳酸/聚己二酸-对苯二甲酸丁二醇酯共混物等温结晶行为及等温热处理对力学性能的影响
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

海南大学青年科学基金项目(qnjj1232);国家自然科学基金地区科学基金资助项目(51263007);海南省产学研一体化专项项目(cxy20150023)


Isothermal Crystallization Behavior of PLA/PBAT Blend and Effects of Isothermal Heating Treatment on Mechanical Performance of PLA/PBAT Blend
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    通过熔融共混法制备聚乳酸(PLA)/聚己二酸-对苯二甲酸丁二醇酯(PBAT)(80/20)共混物,对其等温结晶行为、微观形貌、拉伸性能和维卡软化点(VST)进行研究。并在110 ℃时,利用等温热处理控制样品的结晶度,研究结晶度对样品拉伸韧性和VST的影响。结果发现,随着样品结晶度由9%增大至最大值36%,PLA 基体中的无定形部分不断发生结晶,样品的断裂伸长率由256%骤降至11%,而VST值则由58 ℃提高至143 ℃。这是由PLA 无定形部分与结晶部分巨大的性能差异所造成。当结晶度在27%时,其VST值达到123℃,断裂伸长率维持在160%左右,在增韧和耐热性能之间取得较好平衡。

    Abstract:

    Poly(lactic acid) (PLA)/poly(butylene adipate-co-terephthalate) (PBAT) (80/20) blends were prepared by melt-blending method. Isothermal crystallization behavior, microstructure, tensile properties and Vicat softening temperature (VST) of the PLA/PBAT blends were investigated systematically. PLA/PBAT samples with various crystallinity were obtained under isothermal heat treatment at 110 ℃. And influences of crystallinity on tensile toughness and VST of the samples were studied. As the crystallinity increases from 9% to the maximum value of 36%, the amorphous part of PLA matrix continuously transforms into crystal structure, and elongation at break of the samples drastically drops from 256% to 11%, while the VST value rises from 58 ℃ to 143 ℃. It is attributed to huge nature difference between amorphous part and crystal part of PLA matrix. Notably, when the crystallinity of PLA matrix increases to 27%, its VST value reaches 123 ℃, and the elongation at break keeps around 160%. In this situation, a better balance between toughness and heat deformation resistance is obtained in the PLA/PBAT blends.

    参考文献
    相似文献
    引证文献
引用本文

王思思,庞素娟,徐鼐,潘莉莎.聚乳酸/聚己二酸-对苯二甲酸丁二醇酯共混物等温结晶行为及等温热处理对力学性能的影响[J].高分子材料科学与工程,2016,32(8):38-44. Sisi Wang, Sujuan Pang, Nai Xu, Lisha Pan. Isothermal Crystallization Behavior of PLA/PBAT Blend and Effects of Isothermal Heating Treatment on Mechanical Performance of PLA/PBAT Blend[J]. Polymer Materials Science & Engineering,2016,32(8):38-44.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2016-08-17
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司