EPDM/ENR 宽温域阻尼材料的制备及阻尼机理
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金资助项目(21073066)


Preparation and Damping Mechanism of EPDM/ ENR Damping Material with Wide Temperature Range
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用饱和非极性三元乙丙橡胶(EPDM)和不饱和强极性环氧化天然橡胶ENR-50制备出EPDM/ENR-50二元共混阻尼材料。利用扫描电镜/X射线能谱分析、原子力显微镜分析表明,该共混体系拓宽阻尼温域的机理在于两相中硫化剂的迁移,即共混硫化交联过程中,饱和非极性的EPDM 相中的硫化剂向极性不饱和的ENR-50相迁移,导致二元共混物中ENR-50交联密度比其单独硫化时高,阻尼内耗峰向高温方向外扩,而EPDM 相的交联密度比单独硫化时低,阻尼内耗峰向低温方向外扩,最终得到了温度范围从-72.3℃到52.9℃ (tanδ>0.13)的宽温域阻尼材料。为了改进二元共混橡胶的阻尼性能和力学性能,进一步制备了EPDM/ENR-50/氯丁橡胶(CR)三元共混阻尼材料,所得三元共混胶的有效阻尼(tanδ>0.3)温域范围超过120℃,同时材料具有良好的力学性能。

    Abstract:

    A high-damping material with wide temperature range was prepared by blending ethylene-propylene-diene rubber (EPDM, saturated non-polar rubber) with epoxidized natural rubber (ENR, unsaturated rubber with strong polarity). SEM/XRD and AFM analysis results show that curatives of the blending system can migrate from saturated phase (EPDM) to unsaturated phase (ENR-50) during vulcanization, which lead to higher cross-linking density of ENR-50 phase and lower cross-linking density of EPDM phase compared to its single sulfide respectively, as a result, the loss peak of ENR-50 phase expands to higher temperature while that of EPDM phase expands to lower temperature. Finally, a material with broad damping temperature range from -72.3 ℃to 52.9 ℃ (tanδ>0.13) was obtained. In order to improve the mechanical and damping properties of binary blends, a ternary blends (EPDM/ENR-50/CR) was prepared, which represent good mechanical property as well as high damping property (tanδ>0.3) with a wide temperature range of 120 ℃.

    参考文献
    相似文献
    引证文献
引用本文

黄瑞丽,卢珣,龙娟,吴叔青,姜宏伟. EPDM/ENR 宽温域阻尼材料的制备及阻尼机理[J].高分子材料科学与工程,2016,32(10):119-124. Ruili Huang, Xun Lu, Juan Long, Shuqing Wu, Hongwei Jiang. Preparation and Damping Mechanism of EPDM/ ENR Damping Material with Wide Temperature Range[J]. Polymer Materials Science & Engineering,2016,32(10):119-124.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2016-10-14
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司