纺丝工艺对静电纺纳米纤维包芯纱包覆性能的影响
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金资助项目(51503168);陕西省教育厅重点实验室科研计划(13JS035);西安工程大学纺织科学与工程学科建设经费(10709-0821);西安工程大学研究生创新基金(CX201601);山东省博士后创新项目专项资金资助


Influence of Spinning Process on Covering Property of Core-Spun Nanofiber Yarn
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    提出了一种制备连续纳米纤维包芯纱的方法,利用接地平行铝片作为接收装置,使得纳米纤维平行地搭接在2块铝片之间,处于2块铝片中央的芯纱通过绕自身纱轴旋转,将取向的纳米纤维卷绕在其表面。研究了平行铝片间距、纺丝电压、纺丝距离以及溶液流量对纳米纤维包芯纱包覆率及耐磨性的影响规律。结果表明,利用该方法制备的纳米纤维包芯纱包覆较为均匀,无露芯现象,并且芯纱表面纳米纤维直径分布均匀,排列整齐且具有良好的取向度。当平行铝片间距为2 cm,电压为17 kV,纺丝距离为14 cm,流量为1.0 mL/h时,电纺过程较稳定,包覆效果较好,包覆率最高可达41.9%,并且所得纳米纤维包芯纱的耐磨性与其包覆率成正相关关系,增磨率最大可达142.3%,同时其力学性能较原纱也有略微提高。

    Abstract:

    A method of preparing continuous core-spun nanofiber yarn was proposed. Nanofibers were aligned between two parallel aluminum flakes, and then covered onto surface of core yarn to fabricate core-spun nanofiber yarn through rotation of core yarn. Effects of span distance, applied voltage, collecting distance and flow rate on covering rate and abrasion resistance of core-spun nanofiber yarn were studied. Results show that nanofibers are covered onto surface of core yarn uniformly and possess a good alignment. Diameter distribution is also uniform. In addition, when span distance, applied voltage, spinning distance and flow rate are kept 2 cm,17 kV, 14 cm and 1.0 mL/h, spinning process is stable and covering effect is good. The maximum covering rate and abrasion growth rate could reach 41.9%, 142.3% respectively, and there is a positive correlation between them. The mechanical property of yarn after covering nanofiber also has a slight increase.

    参考文献
    相似文献
    引证文献
引用本文

刘呈坤, 贺海军, 孙润军, 于群, 李博昱.纺丝工艺对静电纺纳米纤维包芯纱包覆性能的影响[J].高分子材料科学与工程,2016,32(12):82-86. Chengkun Liu, Haijun He, Runjun Sun, Qun Yu, Boyu Li. Influence of Spinning Process on Covering Property of Core-Spun Nanofiber Yarn[J]. Polymer Materials Science & Engineering,2016,32(12):82-86.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2016-12-21
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司