Abstract:It is proposed that the separate criteria for polypropylene crease fracture is based on the melt layer of cohesive region forming and thickening is due to the formation heat resulted from the crease extension. The numerical simulation for a separate of cohesive region is based on non-linear heat conduction and convection in the crease and the bulk region near to the active layer with a mechanical extension along the crease axis. The prediction of the crease fracture time for PP is possible when crease thickening rate and cohesive stress are assumed as constant. The results indicate that the temperature at the active layer will exhibit that different temperature distribution in crease region and bulk region for PP, which is due to that the heat conduction in the farmer is much faster rather than latter. The temperature in the central active layer increases as an increase in stress. Also as an increase in a stress the temperature distribution in either crease region or bulk region shows a decrease. As an increase in an extension rate from 0.1 m/s to 1.0 m/s, the temperature distribution decrease. As increases in a stress and a crease thickening rate, respectively, the crease fracture time for PP decreases gradually. Compared with experiment results, it is confirmed that the heat de-cohesive model can be used to simulate the crease fracture time for polypropylene.